Difficulty

Easy

Steps

3

Time Required

                          4 minutes

Sections

1

  • Propeller blades
  • 3 steps

Flags

Step Trimmer

This guide has unnecessary steps. Trim them to be more concise!

  • BackProtocol Slipstream EVO

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Propeller blades
  • With the drone flat on the ground identify which propeller you will be replacing.

With the drone flat on the ground identify which propeller you will be replacing.

1024

Step 2

  • Using two fingers, place them on each side of the propellor near the middle.
  • Pull straight up with force. The propellor will feel as if it will not come off but do not be scared to use some muscle.
  • Warning: Pulling at an angle will result in bending the motor’s needle.

Using two fingers, place them on each side of the propellor near the middle.

Pull straight up with force. The propellor will feel as if it will not come off but do not be scared to use some muscle.

Warning: Pulling at an angle will result in bending the motor’s needle.

Step 3

  • Checking the underside of the propeller there will be a letter which will correspond with each side of the drone
  • On the corner of the drone where the blade mounts onto the motor you will see which blade you should be using.
  • Warning: Failure to match the propeller blade to the right motor may result in the drone not flying.
  • Lining up the propeller blade with the needle, push down until the propeller is flushed.

Checking the underside of the propeller there will be a letter which will correspond with each side of the drone

On the corner of the drone where the blade mounts onto the motor you will see which blade you should be using.

Warning: Failure to match the propeller blade to the right motor may result in the drone not flying.

Lining up the propeller blade with the needle, push down until the propeller is flushed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Michael Dang

Member since: 04/10/2017

301 Reputation

                                      3 Guides authored                  



                       Badges:
                       3

Team

                       UW Tacoma, Team S3-G3, Liner Spring 2017                        

                                                  Member of UW Tacoma, Team S3-G3, Liner Spring 2017 



                    UWT-LINER-S17S3G3                     


                                            4 Members                     


                                            3 Guides authored