Difficulty

Easy

Steps

3

Time Required

                          3 minutes

Sections

1

  • Propeller Guards
  • 3 steps

Flags

2

Step Trimmer

This guide has unnecessary steps. Trim them to be more concise!

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackProtocol Slipstream EVO

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Propeller Guards
  • With the drone flat on the ground, identify which propeller guard you will be replacing.
  • The front of the drone is where there are no wires exposed.

With the drone flat on the ground, identify which propeller guard you will be replacing.

The front of the drone is where there are no wires exposed.

1024

Step 2

  • With the plastic opening tool, pry the side of the guard closest to the front or the back of the drone depending on where you decided to start from.
  • After prying off one side of the guard, pushing down on the same side will release the other side of the clip.
  • Repeat this step for the following side as needed.

With the plastic opening tool, pry the side of the guard closest to the front or the back of the drone depending on where you decided to start from.

After prying off one side of the guard, pushing down on the same side will release the other side of the clip.

Repeat this step for the following side as needed.

Step 3

  • With the replacement guard line up the clips and push the clips into place.
  • After the guard has been attached to the drone, pinch the clips as you push the guards to ensure they are secured.

With the replacement guard line up the clips and push the clips into place.

After the guard has been attached to the drone, pinch the clips as you push the guards to ensure they are secured.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Michael Dang

Member since: 04/10/2017

301 Reputation

                                      3 Guides authored                  



                       Badges:
                       3

Team

                       UW Tacoma, Team S3-G3, Liner Spring 2017                        

                                                  Member of UW Tacoma, Team S3-G3, Liner Spring 2017 



                    UWT-LINER-S17S3G3                     


                                            4 Members                     


                                            3 Guides authored