Difficulty
Easy
Steps
2
Time Required
2 - 3 minutes
Sections
1
- Propeller
- 2 steps
Flags
0
BackProtocol Slipstream WiFi
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Propeller
- Remove the 4.5 mm Philips #00 screw that holds the propeller in place.
Remove the 4.5 mm Philips #00 screw that holds the propeller in place.
1024
Step 2
- Lift the propeller off the device
- Note: When sliding on the new propeller, make sure to align the groove on the propeller with the shaft of the gear. If aligned correctly the propeller should slide on smoothly.
- There are two different propellers that go on the device. Each propeller has a 3 or 4 written on it. Be sure to replace the propeller with a new propeller with the matching number.
Lift the propeller off the device
Note: When sliding on the new propeller, make sure to align the groove on the propeller with the shaft of the gear. If aligned correctly the propeller should slide on smoothly.
There are two different propellers that go on the device. Each propeller has a 3 or 4 written on it. Be sure to replace the propeller with a new propeller with the matching number.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Bryan Chever
Member since: 09/25/2019
135 Reputation
1 Guide authored
Badges:
3
Team
Embry-Riddle Aeronautical University, Team S13-G5, Lamothe Fall 2019
Member of Embry-Riddle Aeronautical University, Team S13-G5, Lamothe Fall 2019
ERAU-LAMOTHE-F19S13G5
2 Members
5 Guides authored
