Difficulty

Difficult

Steps

4

Time Required

                          25 minutes

Sections

1

  • Drone Motor
  • 4 steps

Flags

3

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackProtocol TerraCopter EVO

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Drone Motor
  • Orientate the drone to where the black side of the drone face upwards.
  • On the bottom side of the drone, remove the twenty-two 5mm Phillips #1 screws holding the black frame to the body.
  • There is one screw under the rear light. Pry the opaque cover to access the last screw.

Orientate the drone to where the black side of the drone face upwards.

On the bottom side of the drone, remove the twenty-two 5mm Phillips #1 screws holding the black frame to the body.

There is one screw under the rear light. Pry the opaque cover to access the last screw.

1024

Step 2

  • The plastic frames are subject to cracking.
  • Wires run through both frames.
  • Pry the white body away from the black frame.

The plastic frames are subject to cracking.

Wires run through both frames.

Pry the white body away from the black frame.

Step 3

  • Gently pry the motor from it’s socket.

Gently pry the motor from it’s socket.

Step 4

  • Locate these solder points of the leads on the motherboard.
  • From the front of the drone, the left motor has red and blue leads.
  • From the front of the drone, the right motor has white and black leads.
  • Remove the leads from their points on the motherboard with a soldering iron, respective to each motor.
  • Check out our How to Solder and Desolder Connections guide if you are unfamiliar with soldering practices.

Locate these solder points of the leads on the motherboard.

From the front of the drone, the left motor has red and blue leads.

From the front of the drone, the right motor has white and black leads.

Remove the leads from their points on the motherboard with a soldering iron, respective to each motor.

Check out our How to Solder and Desolder Connections guide if you are unfamiliar with soldering practices.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Derek Vande

Member since: 10/03/2019

217 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       The Citadel Military College of South Carolina, Team S1-G22, Eggleston Fall 2019                        

                                                  Member of The Citadel Military College of South Carolina, Team S1-G22, Eggleston Fall 2019 



                    CMCSC-EGGLESTON-F19S1G22                     


                                            3 Members                     


                                            3 Guides authored