Difficulty

Moderate

Steps

8

Time Required

                          5 minutes

Sections

3

  • Battery
  • 2 steps
  • Propeller
  • 2 steps
  • Motor
  • 4 steps

Flags

0

  • BackProtocol Vento

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Grasp the tail end of the drone where the lip of the battery protrudes.

Grasp the tail end of the drone where the lip of the battery protrudes.

1024

Step 2

  • Pull away from the drone to remove the battery.
  • Do not attempt any repairs or replacements before removing the battery from the drone.

Pull away from the drone to remove the battery.

Do not attempt any repairs or replacements before removing the battery from the drone.

Step 3

              Propeller
  • Place a prying tool under the base of the propeller.

Place a prying tool under the base of the propeller.

Step 4

  • Use a moderate amount of force to pry the propeller out of its base. The propeller should pop off.

Use a moderate amount of force to pry the propeller out of its base. The propeller should pop off.

Step 5

              Motor
  • Unscrew the 4.9mm Phillips #000 screw that is located at the end of the drone’s arm.

Unscrew the 4.9mm Phillips #000 screw that is located at the end of the drone’s arm.

Step 6

  • Hold the base of the arm while gently pulling the motor cover away from the arm.
  • Do not pull too hard because there are wires attaching the motor to the drone. Do not sever the wires.

Hold the base of the arm while gently pulling the motor cover away from the arm.

Do not pull too hard because there are wires attaching the motor to the drone. Do not sever the wires.

Step 7

  • Gently pull the motor out from the plastic cover.
  • Do not squeeze or pull too hard, as to not damage the motor connection.

Gently pull the motor out from the plastic cover.

Do not squeeze or pull too hard, as to not damage the motor connection.

Step 8

  • The motor’s blue and red wires are secured via a white clip. This clip is inserted into a slot in the drone’s leg.
  • Grasp the clip’s edges with a pair of tweezers and pull outward.
  • Do not pull directly on the wires, as to not separate the wires from the clip.

The motor’s blue and red wires are secured via a white clip. This clip is inserted into a slot in the drone’s leg.

Grasp the clip’s edges with a pair of tweezers and pull outward.

Do not pull directly on the wires, as to not separate the wires from the clip.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 4 other contributors 


                    Maria Larcomb

Member since: 02/15/2018

926 Reputation

                                      5 Guides authored                  



                       Badges:
                       18







                                                        +15 more badges

Team

                       USF Tampa, Team S1-G2, Leahy Spring 2018                        

                                                  Member of USF Tampa, Team S1-G2, Leahy Spring 2018 



                    USFT-LEAHY-S18S1G2                     


                                            4 Members                     


                                            6 Guides authored