Difficulty
Moderate
Steps
4
Time Required
15 minutes
Sections
3
- Back Cover
- 2 steps
- Top Cover
- 1 step
- Bottom Plate
- 1 step
Flags
0
BackPSP Go
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Unscrew the four Phillips screws on the back of the PSP Go.
- Rotate the PSP so you can see the top of the device.
- Unscrew the two Phillips screws next to the volume buttons.
Unscrew the four Phillips screws on the back of the PSP Go.
Rotate the PSP so you can see the top of the device.
Unscrew the two Phillips screws next to the volume buttons.
1024
Step 2
- Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.
- Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).
- Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.
Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.
Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).
Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.
Step 3
Top Cover
- Pull the top cover upwards gently from its housing.
Pull the top cover upwards gently from its housing.
Step 4
Bottom Plate
- Remove the two Phillips screws holding the bottom plate.
- Gently lift the bottom plate away from the device.
Remove the two Phillips screws holding the bottom plate.
Gently lift the bottom plate away from the device.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 4 other contributors
Miroslav Djuric
156,282 Reputation
144 Guides authored
Badges:
54
+51 more badges