Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

3

  • Back Cover
  • 2 steps
  • Top Cover
  • 1 step
  • Trigger buttons
  • 3 steps

Flags

0

  • BackPSP Go

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Note: The procedure is exactly the same for the both left and right trigger buttons.

What you need

Step 1

              Back Cover
  • Unscrew the four Phillips screws on the back of the PSP Go.
  • Rotate the PSP so you can see the top of the device.
  • Unscrew the two Phillips screws next to the volume buttons.

Unscrew the four Phillips screws on the back of the PSP Go.

Rotate the PSP so you can see the top of the device.

Unscrew the two Phillips screws next to the volume buttons.

1024

Step 2

  • Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.
  • Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).
  • Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

Use a plastic opening tool around the perimeter of the back cover to loosen it on all sides.

Open the back cover by gently lifting the right side, and rotating it to the left side (as if you were opening a book).

Be careful not to rotate the back cover from the bottom, as you will break the plastic screw holes on top of the device.

Step 3

              Top Cover
  • Pull the top cover upwards gently from its housing.

Pull the top cover upwards gently from its housing.

Step 4

              Trigger buttons
  • The top cover will most likely come off during the repair, so might as well take it off now. Pull it upwards gently from its housing.

The top cover will most likely come off during the repair, so might as well take it off now. Pull it upwards gently from its housing.

Step 5

  • The procedure is exactly the same for the left trigger button.
  • Use a plastic opening tool to gently flip up the left trigger connector.

The procedure is exactly the same for the left trigger button.

Use a plastic opening tool to gently flip up the left trigger connector.

Step 6

  • Unscrew the lone Phillips screw holding the trigger in place. Remove both trigger and retaining plate from the PSP Go.
  • If necessary, repeat steps 2 and 3 to remove the right trigger button.

Unscrew the lone Phillips screw holding the trigger in place. Remove both trigger and retaining plate from the PSP Go.

If necessary, repeat steps 2 and 3 to remove the right trigger button.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Walter Galan

682,038 Reputation

                                      1,203 Guides authored                  



                       Badges:
                       54







                                                        +51 more badges