Puritan Bennett 540 Alarm Resetting Technique Repair Guide

Difficulty

Easy

Steps

Time Required

                          10 minutes

Sections

Puritan Bennett 540 Alarm Resetting Technique
5 steps

Flags

BackPuritan Bennett 540
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Warnings:

When an alarm is triggered, or there is evidence of a patient-ventilator problem, examine the patient first before examining the ventilator.Handle respirator with care, as it may be very hot.Double-check the alarm volume after you have finished working on the alarms, it should be loud enough for the patient’s caretaker to hear.

For more information on resetting the alarm, please refer to page 3-5 (section 3.5) in the service manual.

Step 1

              Puritan Bennett 540 Alarm Resetting Technique

Press the MENU Key to access the Alarm Settings Menu.

Press the MENU Key to access the Alarm Settings Menu.

1024

Step 2

Press the down arrow key to position the cursor on the “Alarm Logs” line, if this is not already the case.

Press the down arrow key to position the cursor on the “Alarm Logs” line, if this is not already the case.

Step 3

Press the Enter key to confirm the selection of the Alarm Menu.

Press the Enter key to confirm the selection of the Alarm Menu.

Step 4

Press the up arrow key to position the cursor on the “Reactivate Paused Alarm” line. The following graphic shows the resulting display.

Press the up arrow key to position the cursor on the “Reactivate Paused Alarm” line. The following graphic shows the resulting display.

Step 5

Press the Enter key for at least three (3) seconds. The following events occur:
A “beep” sounds.
An audible alarm sounds.
An alarm indicator illuminates.
The messages of all active alarms are displayed in a loop in the Ventilation and Alarm menus.
The Audio Paused symbol disappears (if it was displayed).
The Alarm Paused symbol disappears.

Press the Enter key for at least three (3) seconds. The following events occur:

A “beep” sounds.

An audible alarm sounds.

An alarm indicator illuminates.

The messages of all active alarms are displayed in a loop in the Ventilation and Alarm menus.

The Audio Paused symbol disappears (if it was displayed).

The Alarm Paused symbol disappears.

There is no need to reassemble the device, but if the condition persists you can try resetting the audio again.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors

                    kerribyrne

Member since: 04/08/2020

267 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       Cal Poly, Team S7-G7, Paton Spring 2020                        

                                                  Member of Cal Poly, Team S7-G7, Paton Spring 2020 



                    CPSU-PATON-S20S7G7                     


                                            3 Members                     


                                            3 Guides authored

Introduction#

Team#

Introduction

Team