Puritan Bennett 560 Inlet Air Filter Replacement Repair Guide

Difficulty

Very easy

Steps

Time Required

                          1 minute

Sections

Inlet Air Filter
3 steps

Flags

BackPuritan Bennett 560
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Warnings:

• Check the cleanliness of the inlet air filter located on the rear of the ventilator and replace it if necessary. It is recommended that you check or replace this filter at least once per month. When the ventilator is installed on a wheelchair, the environmental conditions may cause the filter to become dirty more rapidly.

• Failure to replace a dirty inlet air filter or operating the ventilator without a filter may damage the ventilator.

• The inlet air filter is not reusable. Do not attempt to wash, clean, or reuse it.

The repair information is also available on pages 139-140 (Section 5, Pages 9-10) of the Service Manual that is linked in the documents section.

What you need

Step 1

              Inlet Air Filter

Locate the inlet air filter on the back of the ventilator.

Locate the inlet air filter on the back of the ventilator.

1024

Step 2

Pinch the center of the filter and pull outward.

Pinch the center of the filter and pull outward.

Step 3

Face the foam surface of the filter towards the ventilator.
Push the filter into position.
To ensure a good seal tuck the corners of the filter into the opening in the housing of the ventilator.
Make sure that the filter is not twisted or distorted when installed and fully covers the opening.

Face the foam surface of the filter towards the ventilator.

Push the filter into position.

To ensure a good seal tuck the corners of the filter into the opening in the housing of the ventilator.

Make sure that the filter is not twisted or distorted when installed and fully covers the opening.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 2 other contributors

                    Kyle Hammer

Member since: 04/07/2020

292 Reputation

                                      2 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team S11-G20, Paton Spring 2020                        

                                                  Member of Cal Poly, Team S11-G20, Paton Spring 2020 



                    CPSU-PATON-S20S11G20                     


                                            2 Members                     


                                            3 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team