Puritan Bennett 560 Internal Battery Replacement Repair Guide

Difficulty

Easy

Steps

3

Time Required

                          3 minutes            

Sections

1

• Internal Battery
• 3 steps

Flags

0

• BackPuritan Bennett 560

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Warnings:

• Ensure the ventilator is powered off and AC power is disconnectedDo not try to open the battery itself under any circumstancesCover the battery terminals with a non-conductive material when not in use to prevent short-circuiting.

The repair information is also available on pages 143-144 (Section 5, Pages 13-14) of the Service Manual that is linked in the documents section.

What you need

Step 1

              Internal Battery               

• REMOVAL
• Locate the battery cover on the rear of the ventilator.

REMOVAL

Locate the battery cover on the rear of the ventilator.

1024

Step 2

• Using the T10 Torx screwdriver, remove the three 8mm screws on the battery cover.
• Two screws are located on the rear of the ventilator, and one on the bottom.
• Slide the battery cover out of the ventilator.
• Remove the battery from the battery cover.

Using the T10 Torx screwdriver, remove the three 8mm screws on the battery cover.

Two screws are located on the rear of the ventilator, and one on the bottom.

Slide the battery cover out of the ventilator.

Remove the battery from the battery cover.

Step 3

• REPLACEMENT
• Install the battery into cover, as shown in figure.
• Make sure the contacts on the battery line up with those in the ventilator.
• Slide the battery and cover together into the housing.
• While applying pressure to the cover, install the two rear screws.
• Install the screw at the bottom of the cover.
• Be careful not to over-tighten any screws.

REPLACEMENT

Install the battery into cover, as shown in figure.

Make sure the contacts on the battery line up with those in the ventilator.

Slide the battery and cover together into the housing.

While applying pressure to the cover, install the two rear screws.

Install the screw at the bottom of the cover.

Be careful not to over-tighten any screws.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    Theo Philliber                     

Member since: 04/07/2020

201 Reputation

                                      1 Guide authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Cal Poly, Team S11-G20, Paton Spring 2020                        

                                                  Member of Cal Poly, Team S11-G20, Paton Spring 2020 



                    CPSU-PATON-S20S11G20                     


                                            2 Members                     


                                            3 Guides authored                     

Theo Philliber - May 30, 2020

Reply

I can’t seem to edit the step titles. They should show:

Step 1: Battery Removal

Step 2:

Step 3: Battery Replacement