Difficulty
Moderate
Steps
5
Time Required
5 minutes
Sections
1
- Camera
- 5 steps
Flags
2
Incorrect Tools
Help make this guide better by using the correct tools in images and/or text.
Better Introduction
Improve this guide by completing or revising its introduction.
BackPurple SmartVP
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Camera
- Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component.
Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component.
1024
Step 2
- Remove the 1.2 cm hex T9 screws and gently open up the device.
Remove the 1.2 cm hex T9 screws and gently open up the device.
Step 3
- Detach the camera cover from the motherboard. Be very careful to not damage any of the components on the motherboard.
Detach the camera cover from the motherboard. Be very careful to not damage any of the components on the motherboard.
Step 4
- Use a plastic spudger to push the black sliding cable connector away from the white bracket.
Use a plastic spudger to push the black sliding cable connector away from the white bracket.
Step 5
- Gently remove the ribbon cable from the connector.
Gently remove the ribbon cable from the connector.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Brian Maulucci
Member since: 09/10/2018
579 Reputation
4 Guides authored
Badges:
4
+1 more badge
Team
Appalachian State University, Team S2-G6, Menagarishvili Fall 2018
Member of Appalachian State University, Team S2-G6, Menagarishvili Fall 2018
APSU-MENAGARISHVILI-F18S2G6
3 Members
4 Guides authored
