Difficulty
Easy
Steps
3
Time Required
1 minute
Sections
1
- Mount
- 3 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackPurple SmartVP
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Mount
- Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component.
Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component.
1024
Step 2
- Locate and release the flap on the side of your device’s mount. This will allow you to slide the adjustable portion of the mount.
Locate and release the flap on the side of your device’s mount. This will allow you to slide the adjustable portion of the mount.
Step 3
- Using a #4.0 flathead screwdriver, unscrew your mount from the bottom and remove the 1.2cm screw.
Using a #4.0 flathead screwdriver, unscrew your mount from the bottom and remove the 1.2cm screw.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Brian Maulucci
Member since: 09/10/2018
579 Reputation
4 Guides authored
Badges:
4
+1 more badge
Team
Appalachian State University, Team S2-G6, Menagarishvili Fall 2018
Member of Appalachian State University, Team S2-G6, Menagarishvili Fall 2018
APSU-MENAGARISHVILI-F18S2G6
3 Members
4 Guides authored
