Difficulty
Moderate
Steps
5
Time Required
5 minutes
Sections
1
- Speaker
- 5 steps
Flags
2
Confusing Text
Some of this guide’s text is confusing, duplicated, or off-topic. Clarify it by editing!
Better Introduction
Improve this guide by completing or revising its introduction.
BackPurple SmartVP
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Speaker
- Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component.
Remove the top bar by removing the 5cm hex T10 screws on the back of the device as shown. Then gently pull off the top bar from the main component.
1024
Step 2
- Remove the 1.2 cm hex T9 screws and gently open up the device.
Remove the 1.2 cm hex T9 screws and gently open up the device.
Step 3
- Disconnect the speakers from the motherboard.
Disconnect the speakers from the motherboard.
Step 4
- Remove the speaker from the plastic shell of the device.
Remove the speaker from the plastic shell of the device.
Step 5
- Release the wires connected to the speaker from the 12-pin connector with a spudger and replace the affected speaker.
Release the wires connected to the speaker from the 12-pin connector with a spudger and replace the affected speaker.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Brian Maulucci
Member since: 09/10/2018
579 Reputation
4 Guides authored
Badges:
4
+1 more badge
Team
Appalachian State University, Team S2-G6, Menagarishvili Fall 2018
Member of Appalachian State University, Team S2-G6, Menagarishvili Fall 2018
APSU-MENAGARISHVILI-F18S2G6
3 Members
4 Guides authored
