Difficulty

Moderate

Steps

5

Time Required

                          2 hours

Sections

1

  • Button, Joystick and Artwork
  • 5 steps

Flags

0

  • BackGame Controller

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Button, Joystick and Artwork
  • Use the Phillips #1 screwdriver to remove the eight 20 mm screws.
  • Remove the metal plate to gain access to the internals of the device.

Use the Phillips #1 screwdriver to remove the eight 20 mm screws.

Remove the metal plate to gain access to the internals of the device.

1024

Step 2

  • Taking a picture or marking cables with masking tape is advised as it will help with the reassembly process.
  • Each button has three cables, unplug these from each one.
  • The joystick has two cables, unplug both of these.
  • The use of ESD safe tweezers may assist with unplugging the cables.

Taking a picture or marking cables with masking tape is advised as it will help with the reassembly process.

Each button has three cables, unplug these from each one.

The joystick has two cables, unplug both of these.

The use of ESD safe tweezers may assist with unplugging the cables.

Step 3

  • Use the Phillips #1 screwdriver to remove the four 10 mm screws.
  • Use a flathead screwdriver to hold the screw in place.
  • Twist off the ball top of the joystick while holding the screw in place with a screwdriver.
  • Remove the joystick and all of it’s components.

Use the Phillips #1 screwdriver to remove the four 10 mm screws.

Use a flathead screwdriver to hold the screw in place.

Twist off the ball top of the joystick while holding the screw in place with a screwdriver.

Remove the joystick and all of it’s components.

Step 4

  • Press in the tabs on the top and bottom of the buttons to remove them.
  • The outline of the buttons are sharp, do exercise caution with the removal of the buttons.

Press in the tabs on the top and bottom of the buttons to remove them.

The outline of the buttons are sharp, do exercise caution with the removal of the buttons.

Step 5

  • Flip the controller over.
  • Peel the six shiny stickers and their epoxy glue off of the controller.
  • Remove the six newly revealed Phillips screws.
  • Remove the acrylic panel.

Flip the controller over.

Peel the six shiny stickers and their epoxy glue off of the controller.

Remove the six newly revealed Phillips screws.

Remove the acrylic panel.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Kevin Vu

Member since: 06/29/2021

121 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       York University, Team S2-G28, Melo-Thaiss Summer 2021                        

                                                  Member of York University, Team S2-G28, Melo-Thaiss Summer 2021 



                    YORK-MELO-THAISS-SU21S2G28                     


                                            1 Member                     


                                            1 Guide authored