Difficulty

Moderate

Steps

12

Time Required

                          10 minutes

Sections

4

  • Battery
  • 3 steps
  • Back Panel
  • 2 steps
  • Motherboard
  • 3 steps
  • Speakers
  • 4 steps

Flags

0

  • BackQualcomm Snapdragon 800 Mobile Development Platform Tablet

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Locate your device.
  • Flip device onto its back.

Locate your device.

Flip device onto its back.

1024

Step 2

  • Remove the tablet’s back cover.

Remove the tablet’s back cover.

Step 3

  • Locate the battery and remove it.
  • If you wish to replace the battery you can do so here.

Locate the battery and remove it.

If you wish to replace the battery you can do so here.

Step 4

              Back Panel
  • Use the Phillips PH1 screwdriver to unscrew the five 4x2.5mm screws that hold the back cover.

Use the Phillips PH1 screwdriver to unscrew the five 4x2.5mm screws that hold the back cover.

Step 5

  • Pop out the back cover.

Pop out the back cover.

Step 6

              Motherboard
  • Start by disconnecting the cables attached to the motherboard
  • use the spudger to lift the connectors vertically off. They should pop off with relative ease
  • The last connector has a yellow tab. Pull up on the tab until the small metal catch lifts up. Then pull straight back to remove the connector from its socket.

Start by disconnecting the cables attached to the motherboard

use the spudger to lift the connectors vertically off. They should pop off with relative ease

The last connector has a yellow tab. Pull up on the tab until the small metal catch lifts up. Then pull straight back to remove the connector from its socket.

Step 7

  • Using the Phillips PH1, remove all 6 of the 3x2.5mm screws (circled in red) holding the motherboard in place.

Using the Phillips PH1, remove all 6 of the 3x2.5mm screws (circled in red) holding the motherboard in place.

Step 8

  • Using the spudger lift the motherboard out of the tablet frame.

Using the spudger lift the motherboard out of the tablet frame.

Step 9

              Speakers
  • Locate the two speakers in each of the bottom corners (left and right).

Locate the two speakers in each of the bottom corners (left and right).

Step 10

  • Use the Phillips PH1 screwdriver to remove the 3x2.5mm screw on the right speaker.

Use the Phillips PH1 screwdriver to remove the 3x2.5mm screw on the right speaker.

Step 11

  • Use the spudger to disconnect the speakers.

Use the spudger to disconnect the speakers.

Step 12

  • Lift the speakers out.

Lift the speakers out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Paola

Member since: 09/25/2017

209 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       University of North Texas, Team S2-G6, Thompson Fall 2017                        

                                                  Member of University of North Texas, Team S2-G6, Thompson Fall 2017 



                    UNT-THOMPSON-F17S2G6                     


                                            3 Members                     


                                            5 Guides authored