Difficulty

Moderate

Steps

5

Time Required

                          10 minutes

Sections

2

  • Rear Casing
  • 1 step
  • Camera
  • 4 steps

Flags

1

Missed a Step

Oops! This guide is currently missing some important steps.

  • BackQuantum Axis A23

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Removing the Case
  • Use plastic opening tools to pry open the rear casing of the your Quantum Axis A23. Slide the tool along the edges to release the plastic tabs.
  • Be careful not to crack front screen in the process.

Use plastic opening tools to pry open the rear casing of the your Quantum Axis A23. Slide the tool along the edges to release the plastic tabs.

Be careful not to crack front screen in the process.

1024

Step 2

              Detaching the Camera from the Motherboard
  • Use small needle nose pliers to carefully remove the yellow ribbon attached to the motherboard.

Use small needle nose pliers to carefully remove the yellow ribbon attached to the motherboard.

Step 3

              Detaching the Camera from the Back of the Screen
  • Use tweezers to remove the black tape holding the camera down.

Use tweezers to remove the black tape holding the camera down.

Step 4

              Attaching New Ribbon to Motherboard Slot
  • Slot the new dual camera ribbon into the motherboard.

Slot the new dual camera ribbon into the motherboard.

Step 5

              Attach New Dual Cameras to Screen
  • Attach dual cameras to the back of the screen with the black tape. Align the cameras with the designated hole in the case.
  • Fold over the camera piece so the camera are on top of each other with lenses facing out and the top as the rear.

Attach dual cameras to the back of the screen with the black tape. Align the cameras with the designated hole in the case.

Fold over the camera piece so the camera are on top of each other with lenses facing out and the top as the rear.

Snap the rear case back on (carefully aligning the back camera with the camera hole on the case) to finish this repair.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Randy Janz

Member since: 01/15/2015

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       USF Tampa, Team 1-5, Tanski Winter 2015                        

                                                  Member of USF Tampa, Team 1-5, Tanski Winter 2015 



                    USFT-TANSKI-W15S1G5                     


                                            3 Members                     


                                            10 Guides authored