Quantum View 10 1 Keyboard Connector Solid State Board Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

2

• Battery
• 3 steps
• Keyboard connector solid state board
• 2 steps

Flags

1

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackQuantum View 10.1

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Open Quantum View case               

• Start by turning the tablet over with the screen down. Carefully use a plastic opening tool to pry the cover off. Start from the corner opposite the hibernate button.

Start by turning the tablet over with the screen down. Carefully use a plastic opening tool to pry the cover off. Start from the corner opposite the hibernate button.

1024

Step 2

              Removing the electrical tape and magnets.               

• Pick up the magnets from the bottom edge of the tablet next to the keyboard connection and put them in a place that they will not get lost. Then carefully remove all 4 strips of electrical tape.

Pick up the magnets from the bottom edge of the tablet next to the keyboard connection and put them in a place that they will not get lost. Then carefully remove all 4 strips of electrical tape.

Step 3

              Unhooking the battery               

• Using a small plastic opening tool; genteelly pull the connection off of the motherboard.

Using a small plastic opening tool; genteelly pull the connection off of the motherboard.

Step 4

              Removing cover plate               

• Using a PH00 Philips screwdriver bit remove 5 screws from the cover on top of the keyboard solid state board.
• Then place cover off to the side.

Using a PH00 Philips screwdriver bit remove 5 screws from the cover on top of the keyboard solid state board.

Then place cover off to the side.

Step 5

              Removing the keyboard  solid state board               

• Using a PH000 Philips screw driver bit remove the two screws on securing the board to the case.
• Then using a plastic opening tool slowly and carefully wedge the tool between the cable ribbon and the black connector portion. Then carefully rock the tool up and down to lift the connector hinge.
• The board can now be removed.

Using a PH000 Philips screw driver bit remove the two screws on securing the board to the case.

Then using a plastic opening tool slowly and carefully wedge the tool between the cable ribbon and the black connector portion. Then carefully rock the tool up and down to lift the connector hinge.

The board can now be removed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    stephen Munchinsky                     

Member since: 04/01/2017

771 Reputation

                                      7 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges                           

Team

                       Gateway Community College Team 1 BPC270 36301                        

                                                  Member of Gateway Community College Team 1 BPC270 36301 



                    Community                     


                                            4 Members                     


                                            7 Guides authored