Difficulty

Moderate

Steps

4

Time Required

                          20 - 25 minutes

Sections

3

  • Rubber Feet
  • 1 step
  • Front Panel
  • 1 step
  • Back Panel
  • 2 steps

Flags

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackRazer BlackWidow Chroma

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rubber Feet
  • Turn the keyboard over so that it is lying flat on its face.
  • Use the iFixit opening tool to pry the rubber feet off the keyboard.

Turn the keyboard over so that it is lying flat on its face.

Use the iFixit opening tool to pry the rubber feet off the keyboard.

1024

Step 2

              Front Panel
  • Use a Phillips #1 screwdriver to remove the six screws on the back of the keyboard.
  • Use an opening tool as a wedge between the front and back panel to pry open the front panel.
  • If the front and back panel won’t separate, DO NOT use excessive force. This may result in damaging the keyboard.
  • Instead, slide the opening tool across the keyboard in between the front and back panel. Go around the edges of the keyboard until the panels disconnect.
  • Flip the keyboard over so the keys are facing up.
  • Grabbing the left and right lips of the front panel, lift both ends up, removing the front panel.

Use a Phillips #1 screwdriver to remove the six screws on the back of the keyboard.

Use an opening tool as a wedge between the front and back panel to pry open the front panel.

If the front and back panel won’t separate, DO NOT use excessive force. This may result in damaging the keyboard.

Instead, slide the opening tool across the keyboard in between the front and back panel. Go around the edges of the keyboard until the panels disconnect.

Flip the keyboard over so the keys are facing up.

Grabbing the left and right lips of the front panel, lift both ends up, removing the front panel.

Step 3

              Back Panel
  • Using a Phillips #1 screwdriver, remove all ten screws found along the outer edges of the keyboard.

Using a Phillips #1 screwdriver, remove all ten screws found along the outer edges of the keyboard.

Step 4

  • Insert the Jimmy along the edges of the back panel and remove the back panel from the device.

Insert the Jimmy along the edges of the back panel and remove the back panel from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Annika Grace Ford

Member since: 02/18/2021

334 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       The Citadel Military College of South Carolina, Team S2-G21, Eggleston Spring 2021                        

                                                  Member of The Citadel Military College of South Carolina, Team S2-G21, Eggleston Spring 2021 



                    CMCSC-EGGLESTON-S21S2G21                     


                                            3 Members                     


                                            4 Guides authored

Kellic Normand - Sep 14, 2021

Reply

Lacks details on where the clips are. It resulted in prying an area where there was one and it broke. We need updated images with those details. If I can I will do do when I reassemble.