Difficulty
Easy
Steps
5
Time Required
8 minutes
Sections
2
- Rear Panel
- 1 step
- Fan
- 4 steps
Flags
0
BackRazer Blade RZ09-0102
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Panel
- Before you begin, be sure to turn off your laptop.
- Using a Torx T5 screwdriver, remove the ten 1/8 inch screws securing the back cover.
- Remove the back cover.
Before you begin, be sure to turn off your laptop.
Using a Torx T5 screwdriver, remove the ten 1/8 inch screws securing the back cover.
Remove the back cover.
1024
Step 2
Fan
- Remove the three black rubber pads that cover the screws holding the fan.
Remove the three black rubber pads that cover the screws holding the fan.
Step 3
- Use the Phillips #0 screwdriver to remove the three 1/4 inch screws.
Use the Phillips #0 screwdriver to remove the three 1/4 inch screws.
Step 4
- Disconnect the wire that goes from the fan into the white connector, but leave the wire attached to the fan.
Disconnect the wire that goes from the fan into the white connector, but leave the wire attached to the fan.
Step 5
- Lift the fan out with your hands.
Lift the fan out with your hands.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Kristopher Yoder
Member since: 10/04/2018
310 Reputation
3 Guides authored
Badges:
7
+4 more badges
Team
Linn Benton Community College, Team S2-G6, Karnes Fall 2018
Member of Linn Benton Community College, Team S2-G6, Karnes Fall 2018
LBCC-KARNES-F18S2G6
4 Members
9 Guides authored
