Difficulty
Easy
Steps
4
Time Required
5 minutes
Sections
2
- Rear Panel
- 1 step
- Speakers
- 3 steps
Flags
0
BackRazer Blade RZ09-0102
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Panel
- Before you begin, be sure to turn off your laptop.
- Using a Torx T5 screwdriver, remove the ten 1/8 inch screws securing the back cover.
- Remove the back cover.
Before you begin, be sure to turn off your laptop.
Using a Torx T5 screwdriver, remove the ten 1/8 inch screws securing the back cover.
Remove the back cover.
1024
Step 2
Speakers
- Using a Phillips #0 screwdriver, remove the two screws holding down the speaker.
Using a Phillips #0 screwdriver, remove the two screws holding down the speaker.
Step 3
- Disconnect the wire by pinching with your fingers and pulling up.
Disconnect the wire by pinching with your fingers and pulling up.
Step 4
- Remove the speaker.
Remove the speaker.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Kristopher Yoder
Member since: 10/04/2018
310 Reputation
3 Guides authored
Badges:
7
+4 more badges
Team
Linn Benton Community College, Team S2-G6, Karnes Fall 2018
Member of Linn Benton Community College, Team S2-G6, Karnes Fall 2018
LBCC-KARNES-F18S2G6
4 Members
9 Guides authored
