Razer Blade Stealth 2016 Hard Drive Replacement Repair Guide

Difficulty

Easy

Steps

6

Time Required

                          7 - 20 minutes            

Sections

1

• Hard Drive
• 6 steps

Flags

Needs More Images

A few more images would make this guide’s procedures crystal clear.

• BackRazer Blade Stealth 12.5 (2016)

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

The hard drive might not be functioning correctly if your laptop says there is no hard drive detected or the computer crashes constantly.

Follow this guide to replace the hard drive on your Razer Blade Stealth 2016.

Make sure the laptop is powered off before beginning this guide.

What you need

Step 1

              Hard Drive               

• Turn the laptop upside down!

Turn the laptop upside down!

1024

Step 2

• There are 10 screws in total, they can be found at the red circles shown in the picture!
• NOTE : you need to use a T5 screwdriver!

There are 10 screws in total, they can be found at the red circles shown in the picture!

NOTE : you need to use a T5 screwdriver!

Step 3

• The hard drive is located under the fan on the left side as shown in the picture!

The hard drive is located under the fan on the left side as shown in the picture!

Step 4

• The hard drive is located under the fan on the left side.
• Slowly peel back the silver piece and black tape beneath it to reveal the hard drive.

The hard drive is located under the fan on the left side.

Slowly peel back the silver piece and black tape beneath it to reveal the hard drive.

Step 5

• Using a Phillips screwdriver, remove the 2.5 mm screw on the left side of the hard drive.
• After you unscrew the hard drive, it will pop out by itself
• The Phillips screw driver is included in the kit that was provided on step 2!

Using a Phillips screwdriver, remove the 2.5 mm screw on the left side of the hard drive.

After you unscrew the hard drive, it will pop out by itself

The Phillips screw driver is included in the kit that was provided on step 2!

Step 6

• Carefully slide the hard drive out from its slot.

Carefully slide the hard drive out from its slot.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 7 other contributors 

                    Lindsay Grant                     

Member since: 10/10/2019

403 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       USF Tampa, Team S1-G4, Leahy Fall 2019                        

                                                  Member of USF Tampa, Team S1-G4, Leahy Fall 2019 



                    USFT-LEAHY-F19S1G4                     


                                            4 Members                     


                                            5 Guides authored