Difficulty
Moderate
Steps
6
Time Required
7 minutes
Sections
2
- Battery
- 3 steps
- Killer 1535 Wireless Card
- 3 steps
Flags
0
BackRazer Blade Stealth 12.5 (2016)
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Before beginning the guide, be sure to power off your computer and disconnect from the charging cable.
What you need
Step 1
Battery
- Use a Torx screwdriver to remove the eight 3 mm screws on the back case.
- Remove the rear cover by prying up lightly starting in one of the corners.
Use a Torx screwdriver to remove the eight 3 mm screws on the back case.
Remove the rear cover by prying up lightly starting in one of the corners.
1024
Step 2
- Use a Phillips screwdriver to remove the six screws securing the battery.
Use a Phillips screwdriver to remove the six screws securing the battery.
Step 3
- Unplug the battery connector from the motherboard.
- Remove the battery from the device.
Unplug the battery connector from the motherboard.
Remove the battery from the device.
Step 4
Killer 1535 Wireless Card
- Carefully remove the auxiliary and main wire from the Killer 1535 wireless card.
Carefully remove the auxiliary and main wire from the Killer 1535 wireless card.
Step 5
- Use a Phillips #00 screwdriver to remove the two 2.61 mm screw holding the card in place.
Use a Phillips #00 screwdriver to remove the two 2.61 mm screw holding the card in place.
Step 6
- Carefully remove the card.
Carefully remove the card.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Kaitlyn Murray
Member since: 10/10/2019
239 Reputation
1 Guide authored
Badges:
7
+4 more badges
Team
USF Tampa, Team S1-G4, Leahy Fall 2019
Member of USF Tampa, Team S1-G4, Leahy Fall 2019
USFT-LEAHY-F19S1G4
4 Members
5 Guides authored
