Razer Blade Stealth 2017 Audio And Usb A Port Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          15 minutes            

Sections

2

• Battery
• 5 steps
• Audio and USB-A Port
• 3 steps

Flags

0

• BackRazer Blade Stealth 13 (2017)

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Before you begin, be sure to turn off your laptop and discharge the battery down to 25%.
• Use a Torx T5 screwdriver to remove the eight, 3mm screws on the bottom cover of the laptop.
• Whenever you remove screws from the device, remember to save and label them.

Before you begin, be sure to turn off your laptop and discharge the battery down to 25%.

Use a Torx T5 screwdriver to remove the eight, 3mm screws on the bottom cover of the laptop.

Whenever you remove screws from the device, remember to save and label them.

1024

Step 2

• Remove the bottom cover of the laptop by sliding it away from the hinge.
• Do not force the cover up!

Remove the bottom cover of the laptop by sliding it away from the hinge.

Do not force the cover up!

Step 3

• Use your fingernail to pry up and disconnect the battery from the motherboard.

Use your fingernail to pry up and disconnect the battery from the motherboard.

Step 4

• Use a Phillips #00 screwdriver to remove the six, 5mm screws securing the battery.

Use a Phillips #00 screwdriver to remove the six, 5mm screws securing the battery.

Step 5

• Remove any tape attached to the battery.
• Use the plastic spudger to pry out the battery.

Remove any tape attached to the battery.

Use the plastic spudger to pry out the battery.

Step 6

              Audio and USB-A Port               

• Use a plastic spudger to lift up the module connector.

Use a plastic spudger to lift up the module connector.

Step 7

• Use a Phillips #00 screwdriver to remove the two, 3mm screws from the USB-A and audio port module.

Use a Phillips #00 screwdriver to remove the two, 3mm screws from the USB-A and audio port module.

Step 8

• Use a plastic spudger to remove the USB-A and audio port module from the chassis.

Use a plastic spudger to remove the USB-A and audio port module from the chassis.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 6 other contributors 

                    Helene Willits                     

Member since: 10/10/2019

718 Reputation

                                      6 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       Cal Poly, Team S11-G3, Regan Fall 2019                        

                                                  Member of Cal Poly, Team S11-G3, Regan Fall 2019 



                    CPSU-REGAN-F19S11G3                     


                                            4 Members                     


                                            7 Guides authored