Difficulty

Moderate

Steps

8

Time Required

                          15 minutes

Sections

2

  • Battery
  • 5 steps
  • SSD
  • 3 steps

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackRazer Blade Stealth 13 (2017)

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Before you begin, be sure to turn off your laptop and discharge the battery down to 25%.
  • Use a Torx T5 screwdriver to remove the eight, 3mm screws on the bottom cover of the laptop.
  • Whenever you remove screws from the device, remember to save and label them.

Before you begin, be sure to turn off your laptop and discharge the battery down to 25%.

Use a Torx T5 screwdriver to remove the eight, 3mm screws on the bottom cover of the laptop.

Whenever you remove screws from the device, remember to save and label them.

1024

Step 2

  • Remove the bottom cover of the laptop by sliding it away from the hinge.
  • Do not force the cover up!

Remove the bottom cover of the laptop by sliding it away from the hinge.

Do not force the cover up!

Step 3

  • Use your fingernail to pry up and disconnect the battery from the motherboard.

Use your fingernail to pry up and disconnect the battery from the motherboard.

Step 4

  • Use a Phillips #00 screwdriver to remove the six, 5mm screws securing the battery.

Use a Phillips #00 screwdriver to remove the six, 5mm screws securing the battery.

Step 5

  • Remove any tape attached to the battery.
  • Use the plastic spudger to pry out the battery.

Remove any tape attached to the battery.

Use the plastic spudger to pry out the battery.

Step 6

              SSD
  • Use a plastic spudger to disconnect one end of the interconnect cable.
  • Remove any tape attached to the interconnect cable.

Use a plastic spudger to disconnect one end of the interconnect cable.

Remove any tape attached to the interconnect cable.

Step 7

  • Lift the black plastic cover and interconnect cable to expose the SSD.
  • Use a Phillips #00 to remove the one, 2mm screw on the left side of the SSD.

Lift the black plastic cover and interconnect cable to expose the SSD.

Use a Phillips #00 to remove the one, 2mm screw on the left side of the SSD.

Step 8

  • Remove the SSD from the motherboard by sliding it out at an angle.

Remove the SSD from the motherboard by sliding it out at an angle.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 6 other contributors 


                    Helene Willits

Member since: 10/10/2019

718 Reputation

                                      6 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team S11-G3, Regan Fall 2019                        

                                                  Member of Cal Poly, Team S11-G3, Regan Fall 2019 



                    CPSU-REGAN-F19S11G3                     


                                            4 Members                     


                                            7 Guides authored