Razer Kraken 7 1 Chroma Speaker Replacement Repair Guide

Difficulty

Difficult

Steps

Time Required

                          15 minutes

Sections

Ear Cushion
3 steps
Speaker
2 steps

Flags

BackRazer Kraken 7.1 Chroma
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Ear Cushion

Grab the ear cushion between your thumb and forefinger.

Grab the ear cushion between your thumb and forefinger.

1024

Step 2

Pull the ear cushion away from the speaker by sliding down to release the cushion from the plastic covering.

Pull the ear cushion away from the speaker by sliding down to release the cushion from the plastic covering.

Step 3

Continue sliding downwards around all edges of the ear cushion until the cushion is fully removed.

Continue sliding downwards around all edges of the ear cushion until the cushion is fully removed.

Step 4

              Speaker

Use the broad edge of the plastic spudger and a lot of force to pop off the speaker from the headset.
Insert the plastic spudger in between the speaker and the headset directly in line with one of the exposed screws of the headset casing, since that is where the four clamps that hold the speaker to the headset are located. These clamps are not visible until after speaker removal.
Make sure to insert the spudger in between the foam buffer-ring and the headset casing instead of in between the speaker and the foam buffer-ring.
Reassembly may be tricky, there is one clamp smaller than others, so you have to align it correctly.

Use the broad edge of the plastic spudger and a lot of force to pop off the speaker from the headset.

Insert the plastic spudger in between the speaker and the headset directly in line with one of the exposed screws of the headset casing, since that is where the four clamps that hold the speaker to the headset are located. These clamps are not visible until after speaker removal.

Make sure to insert the spudger in between the foam buffer-ring and the headset casing instead of in between the speaker and the foam buffer-ring.

Reassembly may be tricky, there is one clamp smaller than others, so you have to align it correctly.

Step 5

Cut both wires connecting the speaker to the headset by using a wire stripper or pair of scissors.
Cut as close as possible to the connections on the speaker circuit board.

Cut both wires connecting the speaker to the headset by using a wire stripper or pair of scissors.

Cut as close as possible to the connections on the speaker circuit board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      13 other people completed this guide.

Author

                                      with 3 other contributors

                    Karissa Sealey

Member since: 03/24/2017

995 Reputation

                                      4 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Baylor, Team S5-G3, Williams Spring 2017                        

                                                  Member of Baylor, Team S5-G3, Williams Spring 2017 



                    BU-WILLIAMS-S17S5G3                     


                                            3 Members                     


                                            8 Guides authored

gianluca - Nov 26, 2018

Hey nice guide, i would like to know which cable color goes where (step 5)

Rino Pasamonte - Feb 28, 2020

Where i can but a replacement headset speaker for Razer Kraken pro neon

Introduction#

What you need#

Team#

Introduction

What you need

Team