Difficulty
Moderate
Steps
12
Time Required
25 minutes
Sections
2
- Razer Naga Trinity Disassembly
- 7 steps
- Scroll Wheel Housing
- 5 steps
Flags
0
BackRazer Naga Trinity
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Razer Naga Trinity Disassembly
- Remove the interchangeable side plate.
Remove the interchangeable side plate.
1024
Step 2
- Remove the mouse’s feet using the opening pick.
Remove the mouse’s feet using the opening pick.
Step 3
- Remove the four 6mm screws by using a JIS #1 screwdriver.
Remove the four 6mm screws by using a JIS #1 screwdriver.
Step 4
- Separate the top mouse housing from the bottom mouse housing using the opening pick.
- Be careful not to tug too hard on the ribbon connector.
Separate the top mouse housing from the bottom mouse housing using the opening pick.
Be careful not to tug too hard on the ribbon connector.
Step 5
- Unlock the ribbon connector that is held down by the main board clips using the spudger’s pointed end.
Unlock the ribbon connector that is held down by the main board clips using the spudger’s pointed end.
Step 6
- Remove the side housing using the opening pick.
Remove the side housing using the opening pick.
Step 7
- Remove the top housing LED 3-Pin connector that is near the main board.
Remove the top housing LED 3-Pin connector that is near the main board.
Step 8
Scroll Wheel Housing
- Remove one 4mm black Phillips #000 screw from the left side of the mouse holding the scroll wheel LED controller board.
- Then pull the LED controller board upwards and out.
Remove one 4mm black Phillips #000 screw from the left side of the mouse holding the scroll wheel LED controller board.
Then pull the LED controller board upwards and out.
Step 9
- Pry and remove the scroll wheel feedback bar from its hold-down clips using the hook end of a halberd spudger.
Pry and remove the scroll wheel feedback bar from its hold-down clips using the hook end of a halberd spudger.
Step 10
- Remove the scroll wheel feedback bar from the scroll wheel by holding down the spring and using angled tweezers to remove it from its placement.
Remove the scroll wheel feedback bar from the scroll wheel by holding down the spring and using angled tweezers to remove it from its placement.
Step 11
- Remove the scroll wheel optical encoder 3-pin connector from the main board by wiggling the connector upwards.
Remove the scroll wheel optical encoder 3-pin connector from the main board by wiggling the connector upwards.
Step 12
- Using the opening tool, pry the black bracket holding the scroll wheel in place backwards until the scroll wheel housing pops out.
Using the opening tool, pry the black bracket holding the scroll wheel in place backwards until the scroll wheel housing pops out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
Kristen Gismondi
Member since: 11/12/2014
69,395 Reputation
176 Guides authored
Badges:
44
+41 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,769 Guides authored
joe - May 28, 2020
Reply
can you give a link for a replacement scroll wheel if possible?
Zzz Zzz - Oct 31, 2021
Reply
nice guide but i sadly didn’t found any housing wheel replacement part ><
