Difficulty

Difficult

Steps

7

Time Required

                          20 - 30 minutes

Sections

2

  • Disassembling RCA CC310 Left Cover
  • 4 steps
  • Main Motherboard
  • 3 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackRCA CC310

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Disassembling RCA CC310 Left Cover
  • Remove the six 7.9mm Phillips #0 screws on the back and bottom.
  • Remove the one 3.8mm Phillips #0 screw on the bottom.
  • Remove the two 7.5mm Phillips #0 screws on the back and bottom.

Remove the six 7.9mm Phillips #0 screws on the back and bottom.

Remove the one 3.8mm Phillips #0 screw on the bottom.

Remove the two 7.5mm Phillips #0 screws on the back and bottom.

1024

Step 2

  • Remove 5.8mm Phillips #1 screw from the side button panel.
  • Slide the viewfinder all the way to the right and remove the 7.9mm Phillips #0 screw.

Remove 5.8mm Phillips #1 screw from the side button panel.

Slide the viewfinder all the way to the right and remove the 7.9mm Phillips #0 screw.

Step 3

  • Pry along the seam on the top side near the buttons with a spudger.

Pry along the seam on the top side near the buttons with a spudger.

Step 4

  • Pull the left panel away from the rest of the camcorder.
  • Unplug the red speaker cable located at the rear of the device.
  • Be careful to not pull too hard. The speaker cable is still connected to the panel and it can rip.

Pull the left panel away from the rest of the camcorder.

Unplug the red speaker cable located at the rear of the device.

Be careful to not pull too hard. The speaker cable is still connected to the panel and it can rip.

Step 5

              Main Motherboard
  • Pull back the plastic tabs along the edges of the motherboard.
  • Disconnect all the cables along the left side of the motherboard.

Pull back the plastic tabs along the edges of the motherboard.

Disconnect all the cables along the left side of the motherboard.

Step 6

  • Disconnect all cables along the bottom of the motherboard.
  • Pull the motherboard away from the camcorder.

Disconnect all cables along the bottom of the motherboard.

Pull the motherboard away from the camcorder.

Step 7

  • Desolder the two black wires holding the motherboard to the camcorder using a soldering iron.

Desolder the two black wires holding the motherboard to the camcorder using a soldering iron.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 9 other contributors 


                    Oliver Adams

Member since: 01/19/2011

629 Reputation

                                      6 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 5-20, Amido Winter 2011                        

                                                  Member of Cal Poly, Team 5-20, Amido Winter 2011 



                    CPSU-AMIDO-W11S5G20                     


                                            4 Members                     


                                            7 Guides authored