Difficulty

Moderate

Steps

7

Time Required

                          15 - 30 minutes

Sections

1

  • Viewfinder
  • 7 steps

Flags

0

  • BackRCA CC310

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Viewfinder
  • Slide a spudger between the plastic rail and the metal tab on the left side of the rail. Push away from the camcorder to release the flap.
  • Pushing the viewfinder assembly to the right makes lifting the flap easier.
  • Slide the lifted flap towards the viewfinder assembly until the viewfinder is free from the rail.

Slide a spudger between the plastic rail and the metal tab on the left side of the rail. Push away from the camcorder to release the flap.

Pushing the viewfinder assembly to the right makes lifting the flap easier.

Slide the lifted flap towards the viewfinder assembly until the viewfinder is free from the rail.

1024

Step 2

  • Unscrew the 7mm ph#0 screw on the underside where the cable connects.
  • Lift the plastic where the cable connects off of the viewfinder assembly.
  • Disconnect the cable inside by pulling it apart.

Unscrew the 7mm ph#0 screw on the underside where the cable connects.

Lift the plastic where the cable connects off of the viewfinder assembly.

Disconnect the cable inside by pulling it apart.

Step 3

  • Unscrew two 7.0mm ph#0 screws on the underside of the viewfinder assembly.
  • Lift the viewfinder plastic assembly up and remove.

Unscrew two 7.0mm ph#0 screws on the underside of the viewfinder assembly.

Lift the viewfinder plastic assembly up and remove.

Step 4

  • Flip back the viewfinder access tab.
  • Unscrew the 7.0mm ph #0 screw next to the mirror.

Flip back the viewfinder access tab.

Unscrew the 7.0mm ph #0 screw next to the mirror.

Step 5

  • Lift off both sides of the plastic assembly.
  • When reassembling, if the housing doesn’t connect properly, try turning the focus wheel.

Lift off both sides of the plastic assembly.

When reassembling, if the housing doesn’t connect properly, try turning the focus wheel.

Step 6

  • Lift the microphone circuit board straight up.
  • Unclip the cable connected to the circuit board.

Lift the microphone circuit board straight up.

Unclip the cable connected to the circuit board.

Step 7

  • Lift plastic housing and guide the wires from underneath.
  • Lift out the entire circuit board and viewfinder.
  • Replace entire circuit board and viewfinder assembly.

Lift plastic housing and guide the wires from underneath.

Lift out the entire circuit board and viewfinder.

Replace entire circuit board and viewfinder assembly.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 7 other contributors 


                    Oliver Adams

Member since: 01/19/2011

629 Reputation

                                      6 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 5-20, Amido Winter 2011                        

                                                  Member of Cal Poly, Team 5-20, Amido Winter 2011 



                    CPSU-AMIDO-W11S5G20                     


                                            4 Members                     


                                            7 Guides authored

Connor Byrley - Jul 25, 2021

Reply

do you know where i can find a relacement one of these parts