Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

2

  • Speaker
  • 3 steps
  • Camera
  • 2 steps

Flags

3

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackRCA Atlas 10 PRO-S RCTS03W12H1

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Speaker
  • Using a separating tool, look for a seam in the plastic casing that looks most accessible.
  • Use the prying tool to separate the front and back casing, working your way around the perimeter.
  • Utilize a card tool or a pick to assist in keeping the case separated.
  • To reassemble the device simply align the two casing halves and pinch to snap together or press down on the edges while the device in on a table.

Using a separating tool, look for a seam in the plastic casing that looks most accessible.

Use the prying tool to separate the front and back casing, working your way around the perimeter.

Utilize a card tool or a pick to assist in keeping the case separated.

To reassemble the device simply align the two casing halves and pinch to snap together or press down on the edges while the device in on a table.

1024

Step 2

  • Flip over the back of the device while keeping it close to the front, the speaker is attached to it.
  • Remove the yellow tape securing the speaker to the back casing.

Flip over the back of the device while keeping it close to the front, the speaker is attached to it.

Remove the yellow tape securing the speaker to the back casing.

Step 3

  • Use the separating tool to pry the speaker from its surface.
  • Use caution when removing the speaker, you may damage the screen.
  • Cut or desolder the wires to replace or repair the speaker.

Use the separating tool to pry the speaker from its surface.

Use caution when removing the speaker, you may damage the screen.

Cut or desolder the wires to replace or repair the speaker.

Step 4

              Camera
  • Using a P00 Phillips screwdriver, remove the three screws securing the black plastic camera housing and remove it.
  • Peel back the beige tape while holding down the camera ribbon cable to prevent tears

Using a P00 Phillips screwdriver, remove the three screws securing the black plastic camera housing and remove it.

Peel back the beige tape while holding down the camera ribbon cable to prevent tears

Step 5

  • Lift the locking tab that is securing the camera ribbon cable.
  • Slide the ribbon cable out from the connector and remove from casing.

Lift the locking tab that is securing the camera ribbon cable.

Slide the ribbon cable out from the connector and remove from casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 


                    Dayne Russell

Member since: 01/27/2015

401 Reputation

                                      4 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       Pasco Hernando, Team 1-1, Prince Winter 2015                        

                                                  Member of Pasco Hernando, Team 1-1, Prince Winter 2015 



                    PHSC-PRINCE-W15S1G1                     


                                            6 Members                     


                                            10 Guides authored