Difficulty

Easy

Steps

4

Time Required

                          1 - 3 minutes

Sections

2

  • Backplate
  • 2 steps
  • Camera
  • 2 steps

Flags

3

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Step Trimmer

This guide has unnecessary steps. Trim them to be more concise!

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackRCA RCT6077W2

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Backplate
  • Remove the two 2.5mm Phillips head screws before attempting to remove the screen from the device.

Remove the two 2.5mm Phillips head screws before attempting to remove the screen from the device.

1024

Step 2

  • Run an opening pick around the edge of the screen to loosen it and begin to pry upward.
  • When the screen comes up like it has in the photo, it should be able to simply be removed from its casing.
  • The buttons on the end of the device will be loose when you remove the screen from the backplate. Be careful not to lose them.

Run an opening pick around the edge of the screen to loosen it and begin to pry upward.

When the screen comes up like it has in the photo, it should be able to simply be removed from its casing.

The buttons on the end of the device will be loose when you remove the screen from the backplate. Be careful not to lose them.

Step 3

              Camera
  • The camera is located in the corner of the motherboard, attached by a ribbon cable. Lift up on the black latch that is holding in the ribbon cable and the cable should pop up and out.
  • Do not use force to try to remove the ribbon cable. The latch may not be lifted up completely, and force can break the ribbon cable away from its connector.

The camera is located in the corner of the motherboard, attached by a ribbon cable. Lift up on the black latch that is holding in the ribbon cable and the cable should pop up and out.

Do not use force to try to remove the ribbon cable. The latch may not be lifted up completely, and force can break the ribbon cable away from its connector.

Step 4

  • Once the cable is removed from the motherboard, the entire camera can simply be removed from the device.

Once the cable is removed from the motherboard, the entire camera can simply be removed from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 5 other contributors 


                    Ryan Williams

Member since: 01/27/2015

1,136 Reputation

                                      4 Guides authored                  



                       Badges:
                       18







                                                        +15 more badges

Team

                       Pasco Hernando, Team 1-2, Prince Winter 2015                        

                                                  Member of Pasco Hernando, Team 1-2, Prince Winter 2015 



                    PHSC-PRINCE-W15S1G2                     


                                            6 Members                     


                                            8 Guides authored

tuesday cannon - Jun 27, 2016

Reply

Where can I get the replacement parts (camera and flex cable)