Difficulty
Moderate
Steps
4
Time Required
15 minutes
Sections
1
- Rear Speaker
- 4 steps
Flags
0
BackRCA RCT6203W46
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Speaker
- Remove these four 4 mm Phillips #00 screws.
Remove these four 4 mm Phillips #00 screws.
1024
Step 2
- Run a spudger tool around the edge of the screen to loosen it and begin to pry upward.
- The screen will be able to be removed once you see it pop up like it has in the photo.
- There are wires attached to the back cover and screen so be careful not to pull them apart.
Run a spudger tool around the edge of the screen to loosen it and begin to pry upward.
The screen will be able to be removed once you see it pop up like it has in the photo.
There are wires attached to the back cover and screen so be careful not to pull them apart.
Step 3
- With a soldering iron, remove the wires from the circuit board.
- Due to the size of the wires, tweezers may be necessary.
With a soldering iron, remove the wires from the circuit board.
Due to the size of the wires, tweezers may be necessary.
Step 4
- Use a metal spudger to pry out the speakers from its housing.
Use a metal spudger to pry out the speakers from its housing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 3 other contributors
Nicholas Alexander
Member since: 09/21/2016
318 Reputation
2 Guides authored
Badges:
13
+10 more badges
Team
UC Davis, Team 1-2, Oliver Fall 2016
Member of UC Davis, Team 1-2, Oliver Fall 2016
UCD-OLIVER-F16S1G2
5 Members
4 Guides authored