Difficulty

Moderate

Steps

7

Time Required

                          10 minutes

Sections

3

  • Disassembling RCA RCT6272W23 Case
  • 2 steps
  • Motherboard
  • 4 steps
  • Rear Camera
  • 1 step

Flags

1

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

  • BackRCA RCT6272W23

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Disassembling RCA RCT6272W23 Case
  • Use a Phillips #00 screwdriver to remove both 4.1 mm screws at the top of the device which hold it together.

Use a Phillips #00 screwdriver to remove both 4.1 mm screws at the top of the device which hold it together.

1024

Step 2

  • Press the plastic opening tool into the space between the front and back portions of the case.
  • Run it along the perimeter of the device to unhook the plastic tabs.
  • Gently pull both sides apart.
  • The speaker is connected to the back cover, so be careful when separating.

Press the plastic opening tool into the space between the front and back portions of the case.

Run it along the perimeter of the device to unhook the plastic tabs.

Gently pull both sides apart.

The speaker is connected to the back cover, so be careful when separating.

Step 3

              Motherboard
  • Use a soldering iron to remove the soldered connections on the motherboard
  • For your safety and to ensure a correct repair, be sure to exercise caution when using the soldering iron.
  • For more information about soldering, check out this guide.

Use a soldering iron to remove the soldered connections on the motherboard

For your safety and to ensure a correct repair, be sure to exercise caution when using the soldering iron.

For more information about soldering, check out this guide.

Step 4

  • Use a philips #00 screwdriver to unscrew the three 4.064mm screws which attach the motherboard to the front of the device.

Use a philips #00 screwdriver to unscrew the three 4.064mm screws which attach the motherboard to the front of the device.

Step 5

  • Use your fingers to pop the three black tabs up to release the flat plastic data transfer cables.

Use your fingers to pop the three black tabs up to release the flat plastic data transfer cables.

Step 6

  • Pull up the motherboard from the rest of the body.

Pull up the motherboard from the rest of the body.

Step 7

              Rear Camera
  • Using a spudger, gently pry off the camera from the back of the display

Using a spudger, gently pry off the camera from the back of the display

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Stephen Radachy

Member since: 03/17/2015

807 Reputation

                                      5 Guides authored                  



                       Badges:
                       18







                                                        +15 more badges

Team

                       Michigan Tech, Team 1-5, Lauer Spring 2015                        

                                                  Member of Michigan Tech, Team 1-5, Lauer Spring 2015 



                    MTU-LAUER-S15S1G5                     


                                            2 Members                     


                                            12 Guides authored