Difficulty

Easy

Steps

7

Time Required

                          10 minutes

Sections

3

  • Handset Battery
  • 2 steps
  • Handset
  • 4 steps
  • Keypad
  • 1 step

Flags

2

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

  • BackRCA Visys 25212

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Handset Battery
  • Place your thumb in the groove on the back of handset. Next, push down with your thumb and then slide the battery cover towards the bottom of the phone to remove the battery cover.

Place your thumb in the groove on the back of handset. Next, push down with your thumb and then slide the battery cover towards the bottom of the phone to remove the battery cover.

1024

Step 2

  • To remove the battery, gently pull up on the white connector located on the left side of the phone.

To remove the battery, gently pull up on the white connector located on the left side of the phone.

Step 3

              Handset
  • Remove the four screws, located at each of the corners within the back encasing, with a small Phillips head screwdriver.

Remove the four screws, located at each of the corners within the back encasing, with a small Phillips head screwdriver.

Step 4

  • Insert a small flathead screwdriver between the face plate and the back of the handset.
  • Gently pry open the handset. You may need to insert the flathead screwdiver at multiple points in order to open the handset.

Insert a small flathead screwdriver between the face plate and the back of the handset.

Gently pry open the handset. You may need to insert the flathead screwdiver at multiple points in order to open the handset.

Step 5

  • Using a small Phillips head screwdriver, remove the single screw (located at the top right) holding the circuit board in place.

Using a small Phillips head screwdriver, remove the single screw (located at the top right) holding the circuit board in place.

Step 6

  • Lift up the circuit board to expose the keypad.
  • Be careful not to disconnect the two wires that connect the speaker to the circuit board.
  • Also, notice the two wires located at the bottom when lifting the circuit board, as these are apart of the charger.

Lift up the circuit board to expose the keypad.

Be careful not to disconnect the two wires that connect the speaker to the circuit board.

Also, notice the two wires located at the bottom when lifting the circuit board, as these are apart of the charger.

Step 7

              Keypad
  • Gently lift out the keypad.

Gently lift out the keypad.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Sandy South

Member since: 01/26/2015

431 Reputation

                                      4 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Pasco Hernando, Team 5-3, Prince Winter 2015                        

                                                  Member of Pasco Hernando, Team 5-3, Prince Winter 2015 



                    PHSC-PRINCE-W15S5G3                     


                                            6 Members                     


                                            8 Guides authored