Redoctane X Plorer Rubber Button Strip Replacement Repair Guide

Difficulty

Easy

Steps

9

Time Required

                          10 - 20 minutes            

Sections

1

• Rubber Button Strip
• 9 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

• BackRedOctane X-Plorer

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Rubber Button Strip               

• Remove the controller’s strap, which will be attached at the points in the red circles.
• If your controller does not have a strap, move to the next step.

Remove the controller’s strap, which will be attached at the points in the red circles.

If your controller does not have a strap, move to the next step.

1024

Step 2

• Remove all nine 12mm screws around the perimeter of the body of the controller, using the Phillips #2 screwdriver.
• Remove the two 15mm screws near the neck of the controller, using the Phillips #2 screwdriver.

Remove all nine 12mm screws around the perimeter of the body of the controller, using the Phillips #2 screwdriver.

Remove the two 15mm screws near the neck of the controller, using the Phillips #2 screwdriver.

Step 3

• Using your hands, remove the body shell.

Using your hands, remove the body shell.

Step 4

• Remove all seven 12mm screws on the neck of the controller using the Phillips #2 screwdriver.

Remove all seven 12mm screws on the neck of the controller using the Phillips #2 screwdriver.

Step 5

• Using your hands, remove the top shell of neck.

Using your hands, remove the top shell of neck.

Step 6

• Remove the left 1.5mm mm screw (as shown) on the key sensor board, using the 1.5mm flathead screwdriver.
• Do not remove the other (right-side) screw on key sensor board, as this can cause damage to the circuitry.

Remove the left 1.5mm mm screw (as shown) on the key sensor board, using the 1.5mm flathead screwdriver.

Do not remove the other (right-side) screw on key sensor board, as this can cause damage to the circuitry.

Step 7

• Using your hands, remove the rubber button strip.

Using your hands, remove the rubber button strip.

Step 8

• Using your hands, insert the replacement strip underneath the key sensor board.

Using your hands, insert the replacement strip underneath the key sensor board.

Step 9

• Align the black dots on the rubber strip with the corresponding button indicator before rescrewing key sensor board.
• The first button will be “A” on Xbox and Wii, and “X” on Playstation.

Align the black dots on the rubber strip with the corresponding button indicator before rescrewing key sensor board.

The first button will be “A” on Xbox and Wii, and “X” on Playstation.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Stephen Haning                     

Member since: 09/30/2021

169 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       University of North Texas, Team 1-1, Boettger Spring 2022                        

                                                  Member of University of North Texas, Team 1-1, Boettger Spring 2022 



                    UNT-BOETTGER-S22S1G1                     


                                            2 Members                     


                                            1 Guide authored