Remington S5500 Power Supply Cable Removal Repair Guide

Difficulty

Easy

Steps

4

Time Required

                          10 minutes            

Sections

1

• Power Supply Cable
• 4 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

• BackRemington S5500

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

All screws on this device are 10mm (0.393 in).

What you need

Step 1

              Power Supply Cable               

• Place the prying tool in between the hair straightener and the aligning cap.
• Push forwards on the prying tool to pop off the aligning cap.

Place the prying tool in between the hair straightener and the aligning cap.

Push forwards on the prying tool to pop off the aligning cap.

1024

Step 2

• Remove the screws with the Phillips #1 screwdriver located underneath the aligning cap, one on each side of the straightener.
• Use the prying tool to remove the aligning rods after the removal of the screws.
• Gently separate each half of the hair straightener.
• The spring located in the middle of this mechanism may pop out and can get lost very easily. Try to separate the two components slowly.

Remove the screws with the Phillips #1 screwdriver located underneath the aligning cap, one on each side of the straightener.

Use the prying tool to remove the aligning rods after the removal of the screws.

Gently separate each half of the hair straightener.

The spring located in the middle of this mechanism may pop out and can get lost very easily. Try to separate the two components slowly.

Step 3

• After the hair straightener is separated, use a Phillips #1 screwdriver to remove the two screws located on the lower half of the straightener.
• Use the prying tool to remove the hinge cover.

After the hair straightener is separated, use a Phillips #1 screwdriver to remove the two screws located on the lower half of the straightener.

Use the prying tool to remove the hinge cover.

Step 4

• Pull upwards while pulling outwards to disconnect the wire from the housing.

Pull upwards while pulling outwards to disconnect the wire from the housing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 1 other contributor 

                    Benjamin Yohe                     

Member since: 07/11/2018

279 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       IUPUI, Team S3-G3, Wilson Summer 2018                        

                                                  Member of IUPUI, Team S3-G3, Wilson Summer 2018 



                    IUPUI-WILSON-SU18S3G3                     


                                            5 Members                     


                                            2 Guides authored                     

Ronnetto - Oct 13, 2019

Reply

Excelente trabajo! Muchas gracias por la información!

alexandru popa - Jan 4, 2021

Reply

is there a place where you can buy and replace the power cable, or the plug ?

alexandru popa - Jan 4, 2021

the slip ring plug that is ..

Kes - Mar 6, 2021

Reply

Hello,

from where did you get the spare power cord ?

Steven Lamprell - Nov 28, 2021

Reply

part number would be helpful?