Difficulty

Moderate

Steps

3

Time Required

Suggest a time??

Sections

1

  • Remove DeLonghi ECAM series top cover
  • 3 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackDeLonghi ECAM Series

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Remove DeLonghi ECAM series top cover
  • Depending on the model, the steam tap/water spout must be removed, there are slight differences here.
  • Pull out the plastic clip on the steam nozzle.
  • Pull the steam nozzle out towards you.

Depending on the model, the steam tap/water spout must be removed, there are slight differences here.

Pull out the plastic clip on the steam nozzle.

Pull the steam nozzle out towards you.

1024

Step 2

  • Carefully pull off the steam faucet toggle. Only use a plastic tool to pry to avoid damaging the bezel.

Carefully pull off the steam faucet toggle. Only use a plastic tool to pry to avoid damaging the bezel.

Step 3

  • If you haven’t already done so, also detach the right-hand cover on the water tank.
  • Remove the four Phillips screws securing the top cover.
  • Lift the top cover up a bit. That might be a bit sticky.
  • Don’t remove the top cover completely, some models still have cables attached to the cup warmer.
  • If there is a cup warmer, then unscrew the nut SW7 with which the two green-yellow cables are connected and loosen it. The two brown cables on the other side can stay if you just put the cover on top.
  • Place the top cover on top, or remove it entirely.

If you haven’t already done so, also detach the right-hand cover on the water tank.

Remove the four Phillips screws securing the top cover.

Lift the top cover up a bit. That might be a bit sticky.

Don’t remove the top cover completely, some models still have cables attached to the cup warmer.

If there is a cup warmer, then unscrew the nut SW7 with which the two green-yellow cables are connected and loosen it. The two brown cables on the other side can stay if you just put the cover on top.

Place the top cover on top, or remove it entirely.

Work the steps in reverse order to reassemble your device.

Cancel: I did not complete this guide.

        oldturkey03 is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

oldturkey03

Author

                                      with 1 other contributor 


                    VauWeh

Member since: 10/19/2015

160,518 Reputation

                                      211 Guides authored                  



                       Badges:
                       41







                                                        +38 more badges