Removing Panasonic Sc Pm31 Top And Side Panels Repair Guide

Difficulty

Very easy

Steps

Time Required

                          5 minutes

Sections

Top and Side Panels
4 steps

Flags

BackPanasonic SC-PM31
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Removing the side and back screws

Remove the five 9 mm #2 Phillips screws from the side panel nearest the power button.
Repeat the process for the opposite panel.
Remove the two 15 mm #2 Phillips screws from the back of the top panel.
Remove the middle 10mm #2 Phillips screw from the back of the top panel.

Remove the five 9 mm #2 Phillips screws from the side panel nearest the power button.

Repeat the process for the opposite panel.

Remove the two 15 mm #2 Phillips screws from the back of the top panel.

Remove the middle 10mm #2 Phillips screw from the back of the top panel.

1024

Step 2

              Removing the panels

If you do not have a plastic opening tool, you can open the system using your finger. However, if you choose to use your hands, make sure to wear gloves. The panel is very sharp.
Swing the back half of the panel slightly away from the unit. Then, starting at the top back corner, slide plastic opening tool through the created gap from back to front. The panel should pop off. Repeat the process on the opposite panel.

If you do not have a plastic opening tool, you can open the system using your finger. However, if you choose to use your hands, make sure to wear gloves. The panel is very sharp.

Swing the back half of the panel slightly away from the unit. Then, starting at the top back corner, slide plastic opening tool through the created gap from back to front. The panel should pop off. Repeat the process on the opposite panel.

Step 3

              Removing the white ribbon wire

Looking in through the side nearest the power button, use your fingers to pull the white ribbon connection toward you, away from the rear circuit board.
The process will require the use of moderate force and can be eased by wiggling the ribbon during removal.

Looking in through the side nearest the power button, use your fingers to pull the white ribbon connection toward you, away from the rear circuit board.

The process will require the use of moderate force and can be eased by wiggling the ribbon during removal.

Step 4

              Removing the top panel

Remove the top panel. You will need to slightly bend the plastic tab outwards, to undo the clasp that is attached to the top.
When reassembling the device, reattach the white ribbon wire (Step 3) before replacing the top panel.

Remove the top panel. You will need to slightly bend the plastic tab outwards, to undo the clasp that is attached to the top.

When reassembling the device, reattach the white ribbon wire (Step 3) before replacing the top panel.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors

                    Curtis Hilgenberg

Member since: 09/29/2014

146 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 13-7, Forte Fall 2014                        

                                                  Member of Cal Poly, Team 13-7, Forte Fall 2014 



                    CPSU-FORTE-F14S13G7                     


                                            5 Members                     


                                            7 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team