Difficulty

Easy

Steps

2

Time Required

                          3 minutes

Sections

1

  • Removing the lid
  • 2 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackJuiceBox EVSE

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Remove lid screws
  • Place JuiceBox on a horizontal surface for easiest work.
  • Three different types of screws were used throughout the history of JuiceBox versions.
  • Philips #2 (silver screw)
  • 2.5mm hex (rusted black screw)
  • T20h security Torx (black screw)
  • If you have a 2.5mm hex screw, be extremely careful with it - they are easy to strip and tend to bind. Use exactly a clean 2.5mm hex bit - don’t substitute a Torx or other size. Press down and turn counterclockwise strongly and carefully to unscrew.
  • Once 4 screws are removed, if your box has LEDs, pay close attention to the next step before proceeding.

Place JuiceBox on a horizontal surface for easiest work.

Three different types of screws were used throughout the history of JuiceBox versions.

Philips #2 (silver screw)

2.5mm hex (rusted black screw)

T20h security Torx (black screw)

If you have a 2.5mm hex screw, be extremely careful with it - they are easy to strip and tend to bind. Use exactly a clean 2.5mm hex bit - don’t substitute a Torx or other size. Press down and turn counterclockwise strongly and carefully to unscrew.

Once 4 screws are removed, if your box has LEDs, pay close attention to the next step before proceeding.

1024

Step 2

              Disconnect LED cable
  • If your box has LEDs, slowly tilt the edge of the case away, revealing the ribbon cable connected to the board.
  • Lift the lock in the direction of the ribbon cable, and you should feel the ribbon cable release.
  • You may now remove the ribbon cable from the board, and place the lid aside.
  • During reassembly, note that the ribbon cable contacts should face opposite the lock slider (as in photo). To re-insert the ribbon cable, first release the lock, insert the cable, then press the lock back down to latch it in place.

If your box has LEDs, slowly tilt the edge of the case away, revealing the ribbon cable connected to the board.

Lift the lock in the direction of the ribbon cable, and you should feel the ribbon cable release.

You may now remove the ribbon cable from the board, and place the lid aside.

During reassembly, note that the ribbon cable contacts should face opposite the lock slider (as in photo). To re-insert the ribbon cable, first release the lock, insert the cable, then press the lock back down to latch it in place.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                    Matt Falcon

Member since: 05/09/2015

1,049 Reputation

                                      13 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges