Difficulty

Easy

Steps

5

Time Required

                          10 minutes

Sections

1

  • conductive film flexible cable
  • 5 steps

Flags

2

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackManette PS4 collector MGSV JDM-030

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Step 1

              conductive film flexible cable
  • Here is the controller to troubleshoot.
  • The controller is made of 2 large plastic parts. To detach them, press the lever as shown in the photo. A gap should form, allowing you to insert an item (like the iFixit Opening Picks).

Here is the controller to troubleshoot.

The controller is made of 2 large plastic parts. To detach them, press the lever as shown in the photo. A gap should form, allowing you to insert an item (like the iFixit Opening Picks).

1024

Step 2

  • Open the controller, taking care not to detach the R2 and L2 triggers. Otherwise, be careful not to lose the springs of these triggers.
  • Déconnecter la batterie en tirant légèrement sur le connecteur blanc relié à la face avant de la manette.
  • Déconnecter le fil électrique qui relie les 2 partie de la manette entre-elles en prenant soin de ne tirer que sur la languette au bout.

Open the controller, taking care not to detach the R2 and L2 triggers. Otherwise, be careful not to lose the springs of these triggers.

Déconnecter la batterie en tirant légèrement sur le connecteur blanc relié à la face avant de la manette.

Déconnecter le fil électrique qui relie les 2 partie de la manette entre-elles en prenant soin de ne tirer que sur la languette au bout.

Step 3

  • The support that holds the battery must be removed by unscrewing the Phillips screw.

The support that holds the battery must be removed by unscrewing the Phillips screw.

Step 4

  • Identify connectors in poor condition and clean them with alcohol.

Identify connectors in poor condition and clean them with alcohol.

Step 5

  • The key pads can then be removed and replaced with new ones.
  • All that remains is to put everything back together.

The key pads can then be removed and replaced with new ones.

All that remains is to put everything back together.

To reassemble your device, follow the instructions in reverse order.

Cancel: I did not complete this guide.

        HelloMacOS is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

HelloMacOS

Author

                    David Jouvin

Member since: 11/24/2017

85 Reputation

                                      2 Guides authored                  



                       Badges:
                       2