Repairing A Panasonic Sa Ht810V With The H02 H07 Error Repair Guide

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Sections

Repairing a Panasonic SA-HT810V with the H02/H07 error
4 steps

Flags

BackPanasonic SA-HT810V
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Repairing a Panasonic SA-HT810V with the H02/H07 error

With the front display of the device facing you, rotate the device 90 degrees counter clockwise.
Remove the screw that is on the right side of the panel facing you.
Now rotate the device 180 degrees and remove the second screw.
Remove all screws with a phillips head screwdriver.

With the front display of the device facing you, rotate the device 90 degrees counter clockwise.

Remove the screw that is on the right side of the panel facing you.

Now rotate the device 180 degrees and remove the second screw.

Remove all screws with a phillips head screwdriver.

1024

Step 2

Rotate the device so that the back faces you.
With a phillips head screwdriver, locate and remove the two screws highlighted by the red circles in image one.

Rotate the device so that the back faces you.

With a phillips head screwdriver, locate and remove the two screws highlighted by the red circles in image one.

Step 3

Before removing top cover make sure that the back of the device is facing you.
Remove the top cover by bending out on the sides, and pulling the cover towards you while applying upward pressure.

Before removing top cover make sure that the back of the device is facing you.

Remove the top cover by bending out on the sides, and pulling the cover towards you while applying upward pressure.

Step 4

Note that the spindle you will be lubing is located underneath the white disk device highlighted in figure one
Tilt the device on its front side until you can see underneath the white circular component mentioned in the note above.
Locate the spindle circled in figure two and apply one or two drops of 3 in 1 lubricating oil to the spindle.

Note that the spindle you will be lubing is located underneath the white disk device highlighted in figure one

Tilt the device on its front side until you can see underneath the white circular component mentioned in the note above.

Locate the spindle circled in figure two and apply one or two drops of 3 in 1 lubricating oil to the spindle.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors

                    Nathan Cheadle

Member since: 04/15/2010

161 Reputation

                                      7 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team 16-5, Maness Spring 2010                        

                                                  Member of Cal Poly, Team 16-5, Maness Spring 2010 



                    CPSU-MANESS-S10S16G5                     


                                            4 Members                     


                                            7 Guides authored

Jerry Wayock - Dec 25, 2014

Thanks you saved my Christmas and nailed this as my wife loves Christmas music in the background for our family dinner. Thanks again and Merry Christmas

Mark Zarraonandia - Oct 19, 2016

I have a Panasonic NV-SD235 and I have a tape stuck with the error H02.

Matthew - Dec 12, 2021

Can’t get screws undone on ours… Help!

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team