Repairing An Fj 3Led Globe Electric Push Light Repair Guide

Difficulty

Difficult

Steps

Time Required

                          15 - 30 minutes

Sections

Repairing an FJ-3LED Globe Electric Push Light
6 steps

Flags

BackLighting
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Soldering is required for this guide. If you are unfamiliar or need a refresher, check out this article on How to Solder and Desolder Connections. Be careful when soldering as the iron is very hot and there is a potential to get burned.

What you need

Step 1

              Repairing an FJ-3LED Globe Electric Push Light

Lift the black lid off of the battery slot and remove the batteries.

Lift the black lid off of the battery slot and remove the batteries.

1024

Step 2

Use the Phillips #1 screwdriver to remove four 1.4 mm screws from the back of the light.
Take the black part out and separate it from the white case.

Use the Phillips #1 screwdriver to remove four 1.4 mm screws from the back of the light.

Take the black part out and separate it from the white case.

Step 3

Identify which part of the lamp is broken.
in this case, one of the connections in the circuit had been disconnected.

Identify which part of the lamp is broken.

in this case, one of the connections in the circuit had been disconnected.

Step 4

For tips on Soldering, see How to Solder and Desolder Connections.
Attach the disconnected wire to its joint using solder and iron tip. Place the tip of the soldering iron against the solder pad.
Melt enough solder onto the solder pad.
Remove both the solder and the soldering iron tip from the connection as soon as enough solder melts onto the pad.
Don’t forget to use gloves.

For tips on Soldering, see How to Solder and Desolder Connections.

Attach the disconnected wire to its joint using solder and iron tip. Place the tip of the soldering iron against the solder pad.

Melt enough solder onto the solder pad.

Remove both the solder and the soldering iron tip from the connection as soon as enough solder melts onto the pad.

Don’t forget to use gloves.

Step 5

Push the circuit into its place.
Click the button to see if the wires are connected .

Push the circuit into its place.

Click the button to see if the wires are connected .

Step 6

If the lights turn on, the connection is perfect in the circuit and the disconnected joint is now connected.
Place the white case on top of the circuit and close it with the Phillips #1 screwdriver.

If the lights turn on, the connection is perfect in the circuit and the disconnected joint is now connected.

Place the white case on top of the circuit and close it with the Phillips #1 screwdriver.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Rojina Saberi

Member since: 05/11/2021

133 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       York University, Team S1-G23, O'Regan Summer 2021                        

                                                  Member of York University, Team S1-G23, O'Regan Summer 2021 



                    YORK-O'REGAN-SU21S1G23                     


                                            1 Member                     


                                            1 Guide authored

Introduction#

What you need#

Team#

Introduction

What you need

Team