Difficulty

Moderate

Steps

7

Time Required

                          30 minutes

Sections

3

  • Battery
  • 2 steps
  • Back Panel
  • 3 steps
  • Logic Board
  • 2 steps

Flags

5

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Inconsistent Images

Updating the images on this guide to be more consistent with the prerequisites would increase its awesomeness.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackHTC Droid Incredible

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Battery
  • Pry off back plastic, starting at the gap provided at the bottom of the phone. A spudger can be used to make this easier.

Pry off back plastic, starting at the gap provided at the bottom of the phone. A spudger can be used to make this easier.

1024

Step 2

  • Remove battery, prying from the provided gap at the upper-right corner of the battery

Remove battery, prying from the provided gap at the upper-right corner of the battery

Step 3

              Back Panel
  • Depress MicroSD to eject it from the side of the case.

Depress MicroSD to eject it from the side of the case.

Step 4

  • Remove 4 corner screws, you may have to remove a “VOID” sticker from one of the screw heads.

Remove 4 corner screws, you may have to remove a “VOID” sticker from one of the screw heads.

Step 5

  • Using a spudger, unclip the nine clips holding the back panel to the front panel, highlighted in included pictures.
  • Start at the top, and work clockwise, being careful not to break the clips.
  • There are, 1, 3, 2, and 3 clips on each side, respectively.
  • After the clips are disengaged, there are no cables holding the back panel in place.

Using a spudger, unclip the nine clips holding the back panel to the front panel, highlighted in included pictures.

Start at the top, and work clockwise, being careful not to break the clips.

There are, 1, 3, 2, and 3 clips on each side, respectively.

After the clips are disengaged, there are no cables holding the back panel in place.

Step 6

              Logic Board
  • Use your spudger to release the remaining clips, disconnecting the ribbon cables from the logic board.

Use your spudger to release the remaining clips, disconnecting the ribbon cables from the logic board.

Step 7

  • Remove 2 Phillips Screws holding the logic board to the front panel.
  • Gently lift the logic board off the front panel.

Remove 2 Phillips Screws holding the logic board to the front panel.

Gently lift the logic board off the front panel.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      6 other people completed this guide.

Author

                                      with 1 other contributor 


                    Mobile Rapid Response Unit

Member since: 05/07/2012

1,941 Reputation

                                      6 Guides authored                  



                       Badges:
                       18







                                                        +15 more badges