Difficulty
Moderate
Steps
6
Time Required
5 - 10 minutes
Sections
1
- Wireless Card
- 6 steps
Flags
0
BackMSI Laptop
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Wireless Card
- Remove the seven 6 mm Philips #0 screws on the bottom of the case.
Remove the seven 6 mm Philips #0 screws on the bottom of the case.
1024
Step 2
- Gently pull from the rear of the case upwards to remove the bottom of the laptop.
Gently pull from the rear of the case upwards to remove the bottom of the laptop.
Step 3
- Remove the yellow tape from the wireless card at the center right of the board.
Remove the yellow tape from the wireless card at the center right of the board.
Step 4
- Using a pair of pliers, remove both wires by pulling straight up from the wireless card.
- Do not jerk or yank too hard as it can break off connectors.
Using a pair of pliers, remove both wires by pulling straight up from the wireless card.
Do not jerk or yank too hard as it can break off connectors.
Step 5
- Remove one Philips #0 screw from the motherboard.
Remove one Philips #0 screw from the motherboard.
Step 6
- Pull card up and out from the motherboard.
- Do not touch gold contacts as it can damage the card.
Pull card up and out from the motherboard.
Do not touch gold contacts as it can damage the card.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Robert Stepp
Member since: 07/24/2020
157 Reputation
1 Guide authored
Badges:
5
+2 more badges
Team
UW Tacoma, Team S1-G16, Cardinal Summer 2020
Member of UW Tacoma, Team S1-G16, Cardinal Summer 2020
UWT-CARDINAL-SU20S1G16
1 Member
1 Guide authored
