Difficulty
Moderate
Steps
6
Time Required
Suggest a time??
Sections
1
- Gecko pressure switch
- 6 steps
Flags
2
In Progress
This guide is a work in progress. Reload periodically to see the latest changes!
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackHot Tub
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Change Gecko pressure switch
What you need
Step 1
Gecko pressure switch
- Locate the pressure valve
Locate the pressure valve
1024
Step 2
- Use a Phillips screwdriver to loosen the screw
- open the lid
Use a Phillips screwdriver to loosen the screw
open the lid
Step 3
- Disconnect the plug from the pressure switch
Disconnect the plug from the pressure switch
Step 4
- Route the pressure switch cable out of the control box
Route the pressure switch cable out of the control box
Step 5
- Cut off the cable ties
- Peel off the rubber
- Pull off the electrical contacts
- It doesn’t matter which way around the contacts are reconnected during assembly
Cut off the cable ties
Peel off the rubber
Pull off the electrical contacts
It doesn’t matter which way around the contacts are reconnected during assembly
Step 6
- Unscrew the pressure switch with an open-end wrench
- Check whether there is any dirt in the openings of the pressure switch and the holder. If necessary, remove the dirt.
Unscrew the pressure switch with an open-end wrench
Check whether there is any dirt in the openings of the pressure switch and the holder. If necessary, remove the dirt.
Follow these steps in reverse order to reassemble your device
Cancel: I did not complete this guide.
oldturkey03 is helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
oldturkey03
Author
with 5 other contributors
AquaWhirlpools
Member since: 05/02/2014
109 Reputation
1 Guide authored
Badges:
5
+2 more badges