Difficulty

Moderate

Steps

11

Time Required

                          20 - 25 minutes

Sections

1

  • The motherboard
  • 11 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackXiaomi Redmi Note 7 Pro

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Step 1

              The motherboard
  • Before you begin, switch off your phone.
  • Heat your phone to about 195 degrees Fahrenheit (90 C).

Before you begin, switch off your phone.

Heat your phone to about 195 degrees Fahrenheit (90 C).

1024

Step 2

  • Lift the back cover to create a gap between the glass and the frame.
  • Insert an opening pick into the gap.

Lift the back cover to create a gap between the glass and the frame.

Insert an opening pick into the gap.

Step 3

  • Start sliding the opening pick from the lower left corner along the side of the device to cut the adhesive
  • Leave the opening pick in the side to prevent the adhesive from resealing.

Start sliding the opening pick from the lower left corner along the side of the device to cut the adhesive

Leave the opening pick in the side to prevent the adhesive from resealing.

Step 4

  • Lift the cover open like a book, but be careful to make sure you do not damage the flex cable while it’s still connected.

Lift the cover open like a book, but be careful to make sure you do not damage the flex cable while it’s still connected.

Step 5

  • Using a screwdriver (1.5 mm ), unscrew 4 screw and remove the bracket holding the connector.

Using a screwdriver (1.5 mm ), unscrew 4 screw and remove the bracket holding the connector.

Step 6

  • Disconnect the connector to avoid a possible short circuit during disassembly.
  • Disconnect connectors and remove the inter-board cable.

Disconnect the connector to avoid a possible short circuit during disassembly.

Disconnect connectors and remove the inter-board cable.

Step 7

  • Using a screwdriver (1.5 mm), unscrew the 7 screws.
  • Remove the cover.

Using a screwdriver (1.5 mm), unscrew the 7 screws.

Remove the cover.

Step 8

  • Pry up on the connector and remove the fingerprint sensor cable.

Pry up on the connector and remove the fingerprint sensor cable.

Step 9

  • Disconnect the connector on PCB, and remove the front facing (selfie) camera.

Disconnect the connector on PCB, and remove the front facing (selfie) camera.

Step 10

  • Disconnect the connectors on the PCB.

Disconnect the connectors on the PCB.

Step 11

  • Pull off and remove the PCB.

Pull off and remove the PCB.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      13 other people completed this guide.                                             


        These translators are helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

VauWeh

Forrest OHara

Troy weglinski

Mariah Adams

and 2 others…

                 +2

Author

                                      with 1 other contributor 


                    Remphone.ru

Member since: 10/02/2019

534 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges

The Comedy King - Jan 22, 2022

Reply

Give Me Your Phone Number..