Difficulty
Moderate
Steps
6
Time Required
5 minutes
Sections
1
- Switch + Motor
- 6 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackDrill - Screwdriver Dexter UP20
Full Screen
Options
History
Save to Favorites
Download PDF
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Step 1
Switch + Motor
- Remove the battery and the mandrel. Loosen the screws with a T10 bit or a T10 screwdriver.
Remove the battery and the mandrel. Loosen the screws with a T10 bit or a T10 screwdriver.
1024
Step 2
- Remove the top shell. Remove the battery connecter, the switch, the Engine + Gearbox assembly and then the LEDs. Detach the Engine from the Gearbox.
Remove the top shell. Remove the battery connecter, the switch, the Engine + Gearbox assembly and then the LEDs. Detach the Engine from the Gearbox.
Step 3
- Assemble the new Switch + Motor assembly to the Gearbox. Position the LEDs.
Assemble the new Switch + Motor assembly to the Gearbox. Position the LEDs.
Step 4
- Install the Engine + Gearbox assembly, the Switch and then the battery cover. Reposition the wiring.
Install the Engine + Gearbox assembly, the Switch and then the battery cover. Reposition the wiring.
Step 5
- Install the LED covers and then reposition the top shell.
Install the LED covers and then reposition the top shell.
Step 6
- Line the top shell.
Line the top shell.
To reassemble your device, follow the instructions in reverse order.
Cancel: I did not complete this guide.
HelloMacOS is helping us fix the world! Want to contribute? Start translating ›
Special thanks to these translators:
100%
HelloMacOS
Author
with 1 other contributor
Antoine Lafillé
Member since: 01/30/2020
780 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
Leroy Merlin
Member of Leroy Merlin
Community
36 Members
223 Guides authored
