Replacing Atari Lynx Speaker Repair Guide

Difficulty

Difficult

Steps

Time Required

Suggest a time??

Sections

Atari Lynx
4 steps
Speaker
2 steps

Flags

BackAtari Lynx
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Atari Lynx

Before disassembling your Atari Lynx, be sure the device is powered off.
Remove any game in the console by opening the right latch and sliding the game to the right.

Before disassembling your Atari Lynx, be sure the device is powered off.

Remove any game in the console by opening the right latch and sliding the game to the right.

1024

Step 2

Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.
Pinch the rear panel with your fingers and lift away from the Atari.

Remove the four 35 mm Phillips #1 screws at each corner of the backside on the Atari Lynx.

Pinch the rear panel with your fingers and lift away from the Atari.

Step 3

Remove the battery panel by pinching the sides with your fingers and lifting it away from the Atari.
Be sure not to tear any wires attached to battery panel.

Remove the battery panel by pinching the sides with your fingers and lifting it away from the Atari.

Be sure not to tear any wires attached to battery panel.

Step 4

Remove the control panel by pinching the sides with your fingers and lifting it away from the Atari.
Be sure not to tear the speaker wire while removing the control panel.

Remove the control panel by pinching the sides with your fingers and lifting it away from the Atari.

Be sure not to tear the speaker wire while removing the control panel.

Step 5

              Speaker

Remove the logic board from the console.
Flip the logic board so the screen is facing down.

Remove the logic board from the console.

Flip the logic board so the screen is facing down.

Step 6

Now you will need to desolder both of the wires connected to the speaker.
If you are having trouble desoldering, click here.
Finally solder the new speaker back on and follow the previous steps in reverse order.

Now you will need to desolder both of the wires connected to the speaker.

If you are having trouble desoldering, click here.

Finally solder the new speaker back on and follow the previous steps in reverse order.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 4 other contributors

                    Tyler Williams

Member since: 01/26/2014

333 Reputation

                                      2 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Cal Poly, Team 1-42, Maness Winter 2014                        

                                                  Member of Cal Poly, Team 1-42, Maness Winter 2014 



                    CPSU-MANESS-W14S1G42                     


                                            5 Members                     


                                            14 Guides authored

RBKing 80 - Mar 3, 2021

Does anyone know the screw sizes for the lynx 2 console please

Introduction#

What you need#

Team#

Introduction

What you need

Team