Replacing Vtech Mobigo Touch Learning System Speaker Repair Guide

Difficulty

Moderate

Steps

Time Required

                          20 minutes

Sections

Case
3 steps
Speaker
4 steps

Flags

BackVTech MobiGo Touch Learning System
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Case

Remove the battery covers and the four batteries.

Remove the battery covers and the four batteries.

1024

Step 2

Remove the four plastic caps with a metal spudger to expose the 6.0 mm Philips JIS #0 case screws.
Remove the eight 6.0 mm JIS #0 case screws.

Remove the four plastic caps with a metal spudger to expose the 6.0 mm Philips JIS #0 case screws.

Remove the eight 6.0 mm JIS #0 case screws.

Step 3

Using a plastic opening tool, separate the two pieces of the case carefully.

Using a plastic opening tool, separate the two pieces of the case carefully.

Step 4

              Speaker

The speaker will be attached to the back of the case.
Unscrew the two 6.0 mm Philips J0 screws.
Careful! The wires are still attached to the back of the case and to the speakers.

The speaker will be attached to the back of the case.

Unscrew the two 6.0 mm Philips J0 screws.

Careful! The wires are still attached to the back of the case and to the speakers.

Step 5

Lift the round speaker with a plastic opening tool.
Remove the two wires connected to the speaker.
You can use wire cutters or regular needle nose pliers to disconnect the wires from the speaker.
Once the wires are disconnected, remove the speaker from the back of the case.

Lift the round speaker with a plastic opening tool.

Remove the two wires connected to the speaker.

You can use wire cutters or regular needle nose pliers to disconnect the wires from the speaker.

Once the wires are disconnected, remove the speaker from the back of the case.

Step 6

Solder the wires to the appropriate spots on the new speaker, making sure that both wires are properly connected.
The wires may be hot.

Solder the wires to the appropriate spots on the new speaker, making sure that both wires are properly connected.

The wires may be hot.

Step 7

Insert the new speaker into the hatch located in the middle part of the panel using a plastic spudger.
Make sure the speaker is the right size for the panel.
Once the speaker is properly placed, screw in the two 6.0 mm Philips J0 screws.
Do not over tighten the screws or the panel will break.

Insert the new speaker into the hatch located in the middle part of the panel using a plastic spudger.

Make sure the speaker is the right size for the panel.

Once the speaker is properly placed, screw in the two 6.0 mm Philips J0 screws.

Do not over tighten the screws or the panel will break.

To reassemble your case, follow the case instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    RBansil

Member since: 08/27/2015

221 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       USF Tampa, Team 8-3, Eyestone Fall 2015                        

                                                  Member of USF Tampa, Team 8-3, Eyestone Fall 2015 



                    USFT-EYESTONE-F15S8G3                     


                                            3 Members                     


                                            16 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team