Difficulty

Moderate

Steps

10

Time Required

                          20 minutes

Sections

2

  • Top Cover
  • 5 steps
  • Wireless Communication Board
  • 5 steps

Flags

0

  • BackResMed AirSense 10

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Be sure to confirm that the internet issues are due to the device itself. The wifi network it is connected to could also be the cause of the problems. To easily test this, just make sure other devices can connect to the internet properly.

What you need

Step 1

              Top Cover
  • Remove the water tub by gently pulling it out.

Remove the water tub by gently pulling it out.

1024

Step 2

  • Pry off the face plate by using your finger or an opening tool.
  • Use a moderate amount of force when prying open.
  • Remove the face plate from the top cover.
  • There will be a clicking sound on either side of the divot when assembling and disassembling.

Pry off the face plate by using your finger or an opening tool.

Use a moderate amount of force when prying open.

Remove the face plate from the top cover.

There will be a clicking sound on either side of the divot when assembling and disassembling.

Step 3

  • Unscrew and remove the two 11.8 mm TR10 Torx screws that were revealed from the face plate being removed.

Unscrew and remove the two 11.8 mm TR10 Torx screws that were revealed from the face plate being removed.

Step 4

  • Unscrew and remove the two 11.8 mm TR10 Torx screws from the bottom of the device.

Unscrew and remove the two 11.8 mm TR10 Torx screws from the bottom of the device.

Step 5

  • Remove the top cover from the rest of the device.

Remove the top cover from the rest of the device.

Step 6

              Wireless Communication Board
  • Place a halberd spudger behind the connector cable.
  • Use a halberd spudger to pull the connector away from the motherboard.

Place a halberd spudger behind the connector cable.

Use a halberd spudger to pull the connector away from the motherboard.

Step 7

Step 8

  • Insert a plastic opening tool in between the side and bottom panel.
  • Pry the side panel away from the bottom panel with the plastic opening tool.
  • Remove the side panel by pulling it away from the device.

Insert a plastic opening tool in between the side and bottom panel.

Pry the side panel away from the bottom panel with the plastic opening tool.

Remove the side panel by pulling it away from the device.

Step 9

  • Push in the clips which secure the board to the side panel with the plastic opening tool.

Push in the clips which secure the board to the side panel with the plastic opening tool.

Step 10

  • Remove the wireless communication board from the side panel.

Remove the wireless communication board from the side panel.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Mitchell Novak

Member since: 01/16/2020

760 Reputation

                                      5 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       Embry-Riddle Aeronautical University, Team 1-1, Rauch Summer 2022                        

                                                  Member of Embry-Riddle Aeronautical University, Team 1-1, Rauch Summer 2022 



                    ERAU-RAUCH-SU22S1G1                     


                                            3 Members                     


                                            5 Guides authored