Difficulty
Easy
Steps
3
Time Required
2 minutes
Sections
1
- Circuit Board in Controller(s)
- 3 steps
Flags
0
BackRetro-Bit Retro Duo
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Circuit Board in Controller(s)
- With the controller on its face, remove the five 6 mm Phillips #1 screws.
- After removing the screws, carefully lift the controller casing .
With the controller on its face, remove the five 6 mm Phillips #1 screws.
After removing the screws, carefully lift the controller casing .
1024
Step 2
- Pinch the top and bottom of the shoulder buttons and lift them out.
- Below each shoulder button, there are small elastic pads. To remove them, pinch the pads and slide them out.
- Removing the elastic pads allows easier circuit board access.
Pinch the top and bottom of the shoulder buttons and lift them out.
Below each shoulder button, there are small elastic pads. To remove them, pinch the pads and slide them out.
Removing the elastic pads allows easier circuit board access.
Step 3
- Carefully lift the circuit board from the controller case.
Carefully lift the circuit board from the controller case.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Evelyn
Member since: 09/25/2017
223 Reputation
2 Guides authored
Badges:
4
+1 more badge
Team
USF Tampa, Team S4-G4, Eyestone Fall 2017
Member of USF Tampa, Team S4-G4, Eyestone Fall 2017
USFT-EYESTONE-F17S4G4
3 Members
10 Guides authored
